Cable óptico activo (AOC) CBO para Palo Alto Networks SFP28-AOC-10M, 10 m

BlueOptics Active Optical Cable (AOC) compatible with Palo Alto Networks SFP28-AOC-10M provides a 10-meter SFP28 connection for 25 Gbps links. The cable is intended for high-speed server, switch and storage interconnects in data center environments where low latency, signal integrity and reduced electromagnetic interference are required. Its optical design supports reliable short-distance backbone and top-of-rack links while maintaining the footprint and plug-and-play simplicity of a direct-attach module.

Advantages

The Active Optical Cable delivers 25 Gbps per channel over a 10 m reach with lower insertion loss and immunity to electromagnetic interference compared with copper direct-attach options. Its duplex optical construction reduces crosstalk and supports consistent latency and signal quality across extended rack-to-rack connections. The small SFP28 form factor preserves port density on switches and servers and simplifies installation without additional transceivers.

Suitable for

• Data center uplinks between switches and aggregation devices
• Top-of-rack (ToR) switch connections to servers and storage
• Short-distance backbone links within server rooms and cabinets
• High-density network environments requiring SFP28 form-factor cables

Key specifications

• Connector type: SFP28-compatible optical duplex
• Nominal data rate: 25 Gbps (per channel)
• Cable length: 10 m optical cable
• Transmission medium: active optical fiber with integrated transceivers
• Typical application: short-reach data center interconnects and ToR links
• Benefits: low latency, reduced electromagnetic interference, compact form factor

How to use

Install the Active Optical Cable by inserting each SFP28-compatible connector into the corresponding SFP28 port on switches, servers or storage devices until it latches. Ensure ports are powered and configured for 25 Gbps operation if necessary. Route the cable through cable management to avoid tight bends and maintain the minimum bend radius recommended for optical fibers. No external transceivers or power sources are required beyond the host ports.

Recommendations

Handle the cable by the connectors and avoid excessive bending or pulling. Verify compatibility with your device firmware and port settings before deployment, and use proper cable management to preserve signal quality and service life.