Cable óptico activo AOC CBO QSFP-100G-AOC-5M 5 m — compatible con Ciena

The AOC QSFP-100G-AOC-5M is a 5 meter Active Optical Cable designed for QSFP ports supporting 100 Gbps links and is compatible with Ciena equipment. This fibre optic cable combines optical transceivers and a fixed fiber assembly in a single, lightweight cable to provide 100G transmission for short-reach interconnects between data center switches, routers and servers. The cable reduces electromagnetic interference, simplifies cabling runs and supports low-latency, high-bandwidth connections in rack-to-rack and shelf-to-shelf environments.

Advantages

This 5 m active optical cable provides predictable 100G performance with reduced heat and power compared with equivalent electrical copper solutions. The integrated optical design eliminates separate transceiver installation and reduces the number of active ports required, simplifying deployment and maintenance. Its optical construction lowers susceptibility to electromagnetic interference and allows for tighter cable management in dense rack environments while maintaining signal integrity over the short-reach distance.

Suitable for

• Rack-to-rack 100G interconnects in data centers
• Connections between switches, routers and servers with QSFP ports
• Short-reach links within network cabinets and equipment shelves
• Environments requiring low-latency, high-bandwidth links with minimal EMI

Key specifications

• Connector type: QSFP (quad small form-factor pluggable) interface
• Rated data rate: 100 Gbps
• Cable length: 5 meters
• Cable type: Active optical assembly integrating transceivers and fiber
• Suitable for short-reach interconnects in data center environments
• Low electromagnetic interference compared with copper alternatives

How to use

Install the cable by plugging each QSFP connector into the corresponding QSFP port on the devices to be linked, ensuring ports support 100G operation and are compatible with active optical assemblies. Handle the cable by the connector housings and avoid tight bends; maintain the manufacturer’s recommended minimum bend radius during routing. Once seated, verify link status on connected devices and confirm 100G link negotiation and optical signal parameters via device management interfaces.

Recommendations

For reliable operation, use this AOC for short-reach connections within the same rack or adjacent racks and avoid running the cable near high-tension cable trays or sources of mechanical stress. Ensure connected equipment firmware and port settings support 100G QSFP modules and check for compatibility with Ciena systems if deploying in a Ciena-managed network.