Cable óptico activo (AOC) CBO Source Photonics SFP-AOC-10G-1M 10 Gbit/s, 1 m

Active Optical Cable (AOC) CBO Source Photonics SFP-AOC-10G-1M is a 1 metre SFP+ form-factor active optical cable that delivers 10 Gbps connectivity for short-reach links. It provides a pre-terminated optical connection in an SFP+ cage-compatible module intended for direct connection between switches, servers and storage equipment. The cable is hot-pluggable and designed to simplify cabling infrastructure while maintaining low-latency, high-throughput links in data centre and enterprise network environments.

Advantages

The AOC module offers 10 Gbps full-duplex bandwidth over a single, factory-terminated optical assembly, reducing the need for separate transceivers and fiber patch cords. Its SFP+ form factor supports straightforward hot-swap installation into compatible ports and helps minimise rack cabling clutter. As an optical connection, it provides electrical isolation and reduced electromagnetic interference compared with copper alternatives, and the short 1 m length is suitable for direct server-to-switch or switch-to-switch connections within racks.

Suitable for

• Short-reach 10 Gbps uplinks between switches and aggregation devices
• Direct server-to-switch or switch-to-switch connections inside racks
• High-speed connections between storage arrays and host adapters
• Data centre top-of-rack and middle-of-row cabling where 1 m length suffices

Key specifications

• Form factor: SFP+ (hot-pluggable)
• Data rate: 10 Gbps (full duplex)
• Cable type: Active optical cable (pre-terminated optical assembly)
• Length: 1 metre
• Typical use case: short-reach intra-rack and adjacent-rack links
• Latency: low, suitable for high-throughput applications

How to use

Install the AOC by inserting each SFP+ connector into the compatible SFP+ port on the devices to be linked until the module clicks into place. The module is hot-pluggable so it can be installed or removed without powering down compliant equipment. Verify link status and speed on both ends via the device management interface or LED indicators. Avoid excessive bending of the optical cable and ensure the 1 m length meets the physical routing requirements within the rack or cabinet.

Recommendations

Use the AOC for short, direct connections where 1 m reach is sufficient; for longer distances select appropriate optical transceivers or longer AOC assemblies. Handle connectors by the module body and store unused ends with protective caps to prevent contamination. Confirm compatibility with the host devices' SFP+ ports and firmware support for AOC modules to ensure reliable link establishment.