Cable óptico activo CBO AOC Lenovo SFP+ SFP-AOC-10G-20M 10G 20 m

The CBO AOC Lenovo SFP+ SFP-AOC-10G-20M 10G Active Optical Cable 20 m is a factory-terminated fiber optic link designed for direct connection between SFP+ ports on servers, switches and storage devices. This 20‑metre active optical cable supports 10 Gigabit per second throughput and uses SFP+ form-factor connectors for plug-and-play compatibility with equipment that accepts SFP+ modules. The AOC construction delivers optical transmission over a flexible cable assembly, reducing weight and susceptibility to electromagnetic interference compared with equivalent copper cables while maintaining low latency for short-range data center links.

Advantages

The active optical design provides stable 10 Gbps connectivity over 20 m with lower power consumption and reduced heat dissipation compared with active copper alternatives. Optical transmission eliminates common-mode electromagnetic interference and improves signal integrity in dense cabling environments. Factory termination and SFP+ compatibility simplify installation and reduce connectorization errors. The cable's flexible jacket and light weight make routing and cable management easier in racks and conduit runs.

Suitable for

• Interconnects between SFP+ ports on network switches and aggregation devices
• Server-to-switch links in data center top-of-rack and end-of-row deployments
• Storage area network connections requiring 10 Gbps short-range links
• Environments where EMI must be minimized or copper cabling is impractical

Key specifications

• Nominal data rate: 10 Gigabits per second
• Cable type: Active optical cable (AOC) with factory-terminated SFP+ connectors
• Length: 20 metres
• Connector type: SFP+ form-factor optical connectors (plug-in on host devices)
• Transmission medium: Multimode optical link with integrated transceivers
• Typical use: Short-range data center interconnects

How to use

Install the cable by inserting each SFP+ plug into the corresponding SFP+ port on the devices to be connected. Ensure both host ports are powered and support 10 Gbps operation. Avoid sharp bends or kinks in the optical cable; follow minimum bend radius guidelines where supplied by the equipment manufacturer. No additional fiber polishing or termination is required because the cable is factory-terminated and contains integrated transceivers. Verify link status through device LEDs or management interfaces after insertion.

Recommendations

For reliable performance, route the cable to prevent continuous mechanical stress, keep it clear of high-heat sources, and maintain bend radii indicated by the vendor. Use these active optical cables in matched SFP+ ports and compatible firmware environments; consult device compatibility lists if operating with vendor-specific link validation or encryption features. Periodically inspect connectors for contamination and clean with appropriate fiber-optic cleaning tools if required.