Cable óptico activo CBO AOC para Palo Alto Networks PAN-QSFP-AOC-30M, 30 m

CBO Active Optical Cable AOC for Palo Alto Networks PAN-QSFP-AOC-30M, 30 m is a 30-metre active optical link designed for QSFP ports. The cable provides high-speed optical connectivity for switch-to-switch links, server uplinks and other high-bandwidth network equipment in data centers and enterprise networks. Its optical construction enables longer distances than copper equivalents, reduces electromagnetic interference and supports passive plug-and-play installation into compatible QSFP sockets.

Advantages

This 30 m AOC delivers stable high-throughput connections with low signal attenuation over longer runs compared to copper. The all-optical link reduces susceptibility to EMI and removes the need for transceiver modules and separate fiber patching for many applications. The cable’s integrated QSFP terminations enable straightforward, tool-free installation and minimize rack cabling complexity.

Suitable for

• Data center switch-to-switch interconnects
• High-speed server uplinks and aggregation links
• Short to mid-range optical runs within telecom rooms and racks
• Environments where EMI reduction and simplified cabling are required

Key specifications

• Cable type: Active Optical Cable (AOC)
• Connector type: QSFP / QSFP (QSFP+ compatible physical QSFP form-factor)
• Length: 30 metres
• Medium: optical fiber with active transceivers integrated in the cable ends
• Typical use: multi-gigabit to 40 Gbps-class links (dependent on QSFP module capabilities and network equipment)
• Installation: plug-and-play, no additional transceiver modules required

How to use

To install, power down or follow hot-swap procedures recommended by your equipment vendor, then insert each QSFP connector into the corresponding QSFP port until it seats. Verify link status via the switch or server management interfaces and confirm that the negotiated speed matches network configuration. Route the cable to avoid sharp bends and secure it within rack cable management to prevent stress on connectors. For removal, follow vendor guidance to avoid damage to the optical interfaces.

Recommendations

Use this AOC for intra-rack and inter-rack optical connections where 30 m reach provides a simpler and more EMI-robust alternative to copper. Ensure compatibility with the QSFP port specifications of your network equipment and verify supported data rates before deployment. Avoid tight bends and exposure to mechanical strain to maintain signal integrity.