Cable óptico activo CBO AOC SFP+ AOC-SFP-10G-3M-BO — 3 m, 10 Gbit/s

Active Optical Cable CBO AOC-SFP-10G-3M-BO is a 3-metre SFP+ optical direct-attach solution engineered for 10 Gbit/s links between SFP+ ports. The integrated transceiver ends and fiber construction replace separate twinax or transceiver-plus-fiber assemblies to simplify rack cabling in data centres, server rooms and storage environments. The cable delivers low latency and reduced electromagnetic interference compared with copper alternatives, while maintaining a compact, flexible connection for short-reach high-speed interconnects.

Advantages

The BlueOptics AOC provides a factory-assembled, plug-and-play SFP+ link with consistent 10 Gbit/s performance over a 3 m reach. Its active optical design minimizes crosstalk and eliminates bulky copper twinax cable limitations, lowering signal loss and improving link stability. Built-in SFP+ form-factor ends ensure compatibility with standard SFP+ ports and reduce installation time by removing the need for separate transceivers or patch cables.

Suitable for

• High-speed server-to-switch connections in data centres and server rooms
• Top-of-rack and end-of-row switch interconnects
• Storage area network links and SAN fabrics requiring 10 Gbit/s
• Short-range connections inside racks and between adjacent racks

Key specifications

• Connector type: SFP+ form factor (integrated transceiver ends)
• Data rate: up to 10 Gbit/s
• Length: 3 metres
• Transmission medium: active optical cable (AOC)
• Typical reach: short-range interconnects (rack-to-rack or within-rack)
• Electrical characteristics: low latency, reduced electromagnetic interference compared with copper

How to use

Install the AOC by inserting each SFP+ module end into the corresponding SFP+ port until the latch engages. Confirm link status on connected devices and verify negotiated speed of 10 Gbit/s in the host interface diagnostics. No separate transceivers, fiber patch cords, or additional configuration are required in most environments; standard hot-plug procedures and port management apply. For removal, depress the SFP+ latch and gently withdraw the connector.

Recommendations

Use the cable for short-range 10 Gbit/s interconnects where reduced electromagnetic interference and compact cable routing are priorities. Avoid tight bends near the connector ends and maintain recommended rack routing practices to prevent strain. Verify compatibility with switch and server vendors’ SFP+ ports if vendor RBAs or compatibility lists are required.