Cable óptico activo CBO AOC SFP+ SFP-AOC-10G-7M 10G, SFP+ a SFP+, 7 m

CBO AOC SFP-AOC-10G-7M is a 7-metre active optical cable with SFP+ connectors on both ends, engineered to support 10 Gbps links between SFP+ ports. Intended for dense rack and data centre environments, this SFP+ to SFP+ AOC delivers a fibre-based alternative to copper Direct Attach Cables, offering low latency and minimal electromagnetic interference while simplifying cable management across switches, servers and storage arrays.

Advantages

The active optical construction provides stable 10 Gbps throughput over 7 metres with lower heat and weight compared to equivalent copper assemblies. The hot-pluggable SFP+ form factor enables quick insertion and replacement without powering down equipment. The optical medium reduces susceptibility to EMI and crosstalk, improving signal integrity in high-density installations and mixed-cable environments.

Suitable for

• Interconnects between SFP+ ports on switches and routers in racks
• Server to top-of-rack switch connections in data centres
• Short-distance storage area network links and SAN fabrics
• High-density patching panels and aggregation aisles

Key specifications

• Connector type: SFP+ to SFP+
• Data rate: 10 Gbps
• Length: 7 metres
• Media: active optical cable (AOC)
• Form factor: hot-pluggable SFP+ modules integrated into the cable ends
• Typical applications: server, switch and storage interconnects

How to use

Ensure both devices have compatible SFP+ ports and that network interfaces and firmware support 10 Gbps links. Insert each SFP+ connector into the corresponding port until it latches; no additional transceivers or fibre patching is required. Monitor link status on the connected devices and verify negotiated speed and duplex. For replacement or reconfiguration, remove the cable by depressing the connector latch and pulling straight out to avoid damaging the port.

Recommendations

For reliable performance, route the cable to avoid sharp bends and mechanical stress, maintain a bend radius consistent with manufacturer guidance, and keep the connector dust caps in place prior to installation. Use AOC links within the specified 7 m distance and confirm compatibility with the host equipment when combining modules from different vendors.