Cable óptico activo CBO (AOC) Source Photonics SFP-AOC-10G-7M 10Gbps 7 m

CBO Active Optical Cable (AOC) Source Photonics SFP-AOC-10G-7M is a 7-metre, pre-terminated SFP+ AOC designed for 10Gbps short-reach connections. The cable integrates active optical transceivers and a multimode fibre link in a single assembly that plugs directly into SFP+ ports on switches, servers or storage devices. It is intended to simplify cabling in data centre and enterprise networking environments by removing the need for separate transceivers and patch cords while offering consistent performance and low power consumption.

Advantages

The integrated design reduces component count and installation time compared with separate transceiver and patch-cord solutions. By using an optical medium and active components within the cable, it provides stable 10Gbps links with predictable latency and low heat dissipation at the host ports. The pre-terminated 7-metre length minimises on-site termination errors and facilitates orderly cable management in rack and row deployments.

Suitable for

• Short-reach 10Gbps uplinks between switches in data centres
• Direct connections from servers to top-of-rack switches
• 10Gbps links between storage arrays and host controllers
• Environments requiring reduced power and simplified cabling

Key specifications

• Interface: SFP+ (hot-pluggable)
• Data rate: 10 Gbps (full duplex)
• Length: 7 metres
• Transmission medium: active optical cable with integrated transceivers
• Typical use: short-reach interconnects within racks or across adjacent racks
• Power: low host-side power consumption compared with separate transceiver plus patch-cord setups
• Latency: predictable, suitable for latency-sensitive applications within the specified reach

How to use

Insert each SFP+ connector into compatible SFP+ host ports until the connector latches. Confirm link status through the host device LEDs or management interface. No separate fibre patching or transceiver modules are required. Ensure both ends are fully seated and that connected devices support 10Gbps SFP+ AOC modules. Avoid tight bends and mechanical strain on the cable; handle the cable by the connector housings during insertion and removal.

Recommendations

For reliable operation, route the 7-metre cable to minimise sharp bends and secure it to rack cable management to prevent stress on the connectors. Verify compatibility with the SFP+ port vendor or host device to ensure proper link negotiation and power parameters. Use AOC solutions for short, fixed-length links where predictable latency and reduced power are priorities.