Cable óptico activo CBO QSFP-100G-AOC-5M 100G 5m

The Active Optical Cable CBO QSFP-100G-AOC-5M 100G 5m is a factory-terminated, high-speed optical interconnect that delivers 100 Gbit/s over a 5-meter length. Designed for short-reach links between QSFP ports, this BlueOptics AOC reduces cabling bulk and eliminates the need for separate transceivers and fiber patch cords. It provides low latency and stable throughput for consolidated rack and row connections in data centers and enterprise networking environments.

Advantages

This Active Optical Cable integrates transceiver functionality into a single, lightweight assembly, lowering power consumption compared with equivalent copper solutions and preserving signal integrity over the 5 m link. The all-in-one design simplifies installation and reduces points of failure. Factory termination and testing ensure predictable performance for 100G QSFP connections and easier inventory management when deploying high-density fabrics.

Suitable for

• Interconnects between QSFP-enabled switches and routers within a rack or across adjacent racks
• Direct server-to-switch connections requiring 100Gbps bandwidth
• Storage area network (SAN) aggregation and spine-leaf topologies in data centers
• High-performance computing clusters with short-reach optical links

Key specifications

• Data rate: 100 Gbit/s aggregate
• Connector type: QSFP form-factor factory-terminated optical interfaces
• Length: 5 metres (single fixed cable assembly)
• Reach: short-reach multimode optical link optimized for intra-rack and adjacent-rack connections
• Latency: low, suitable for latency-sensitive network fabrics
• Power: integrated modules designed for low power consumption compared with equivalent electrical copper interconnects
• Compatibility: intended for QSFP ports supporting active optical cable assemblies

How to use

Connect each QSFP plug to the corresponding QSFP port on the devices to be linked, ensuring the connectors are fully seated and the latches engage. No separate SFP/QSFP transceivers or fiber patch cords are required; the cable is pre-terminated and ready for immediate use. Verify that connected equipment supports 100G operation and, if necessary, enable the appropriate port settings or firmware features. Handle the cable by its reinforced strain-relief areas and avoid tight bends to maintain optical performance.

Recommendations

Install and route the cable within appropriate cable management trays to prevent mechanical stress. Maintain the minimum bend radius specified by the manufacturer and keep the cable away from sharp edges and heat sources. Before deployment in production, test the link at the intended data rates and check device compatibility to ensure stable 100G operation.