Cable óptico activo CBO SFP+ 10G 20 m para SonicWall (SFP-AOC-10G-20M)

CBO SFP+ Active Optical Cable 10G 20m for SonicWall is a factory-terminated SFP+ cable assembly that provides a 10 Gigabit Ethernet connection over a 20 metre active optical link. The single-cable solution integrates SFP+ connectors with an optical cable and active components to deliver 10G throughput between compatible SFP ports in switches, servers or security appliances. The cable reduces electromagnetic interference compared with copper DACs and eliminates the need for separate transceivers and patch fiber, simplifying rack-to-rack or within-rack cabling in data centre and enterprise network environments.

Advantages

The active optical cable delivers consistent 10G bandwidth over 20 metres with lower weight and improved EMI immunity versus copper alternatives. Because the cable is factory-terminated and integrated with SFP+ connectors, installation time is reduced and compatibility issues from mismatched transceivers and patch cords are minimised. The solution supports hot-pluggable SFP+ ports and helps maintain predictable signal quality for short-range links in dense network deployments.

Suitable for

• Server-to-switch 10G connections in data centres
• Switch-to-switch uplinks inside racks or between adjacent racks
• Security appliance SFP+ ports where a 20 m optical link is required
• Environments needing reduced electromagnetic interference compared to copper cabling

Key specifications

• Form factor: SFP+ active optical cable assembly
• Data rate: 10 Gigabit Ethernet
• Length: 20 metres
• Connector type: SFP+ on both ends (hot-pluggable)
• Transmission medium: active multimode optical link with integrated electronics
• Typical use range: short-reach links up to 20 m

How to use

Insert each SFP+ connector into the matching SFP+ port on your devices until the latch engages. Ensure both endpoints support 10G SFP+ connections and that ports are enabled in the device configuration. Because the cable is an integrated active optical assembly, no separate transceivers or patch fibre are required. After installation, monitor link status on the connected devices and verify 10G link negotiation and stable signal indicators in the equipment management interface.

Recommendations

Handle the cable by the connector housings and avoid excessive bending or sharp kinks in the optical cable; maintain the manufacturer’s minimum bend radius. Use in indoor, controlled environments and route the cable to avoid mechanical strain, heat sources and sources of physical damage. For best results, confirm firmware and compatibility notes for your SonicWall or other SFP+ devices prior to deployment.