Cable óptico activo CBO SFP-AOC-10G-10M IBM 10 m SFP+ 10Gbps

Active Optical Cable CBO SFP-AOC-10G-10M IBM is a 10 m SFP+ direct-attach cable engineered for 10 Gbps links between compatible SFP+ ports. It is intended for short-reach, high-speed interconnects in data center and enterprise rack environments, providing a single-cable optical solution that reduces electromagnetic interference and simplifies cabling compared with separate fiber transceivers and patch cords. The cable supports low-latency transmission suitable for switch-to-switch, server-to-switch and server-to-storage connections over a 10 metre span.

Advantages

The Active Optical Cable offers native support for 10 Gbps SFP+ links in a plug-and-play form factor that eliminates the need for separate transceivers and fiber patching. Its optical design reduces EMI and crosstalk while enabling lower power consumption than some copper alternatives at equivalent distances. The 10 m length provides a balance between reach and density, helping to simplify rack-to-rack and intra-rack cabling and to maintain signal integrity for high-throughput applications.

Suitable for

• Data center switch-to-switch connections
• Server-to-switch uplinks in rack deployments
• Server-to-storage links requiring 10 Gbps throughput
• High-density cabling environments where reduced EMI is needed

Key specifications

• Connector format: SFP+ direct-attach optical cable
• Nominal data rate: 10 Gbps
• Nominal length: 10 metres
• Transmission medium: active optical (fiber-based) twinax replacement
• Typical latency: low, suitable for latency-sensitive network links
• Compatibility: designed for SFP+ ports supporting 10 Gbps links

How to use

Insert each SFP+ connector into the corresponding 10 Gbps SFP+ port on your network equipment until the latch engages. Ensure both ends are seated and that the connected devices are powered and configured for 10 Gbps SFP+ links. No additional transceivers or fiber patch cords are required. Monitor the link status through the device management interface to confirm successful negotiation and link integrity.

Recommendations

Use the cable for short-reach, high-speed links up to 10 metres in structured cabling environments; avoid tight bending near the connector and maintain proper airflow in racks. Verify port compatibility and firmware support in the connected devices before deployment to ensure reliable operation.