Cable óptico activo CBO SFP28-AOC-10M para puertos SFP28 de 25Gb, 10 m

CBO SFP28-AOC-10M for 25Gb SFP28 ports, 10 m is a pre-terminated active optical cable designed for short-reach 25 Gigabit Ethernet links. The 10-metre AOC provides a single-cable fiber connection between compatible SFP28 ports on switches, servers and storage devices. Built for compact deployments, it combines low latency and stable signal integrity for top-of-rack, server interconnect and switch-to-switch scenarios where a vendor-compatible SFP28 form factor is required.

Advantages

The AOC offers plug-and-play installation with pre-attached SFP28 connectors, eliminating the need for field termination or transceiver modules. Its active optical design delivers low power consumption and consistent 25Gb/s performance over a 10 m range while reducing electromagnetic interference compared with copper solutions. The thin, lightweight cable simplifies routing in dense racks and improves airflow in data center environments.

Suitable for

• Top-of-rack connections in data centers
• Server-to-server or server-to-switch interconnects
• Switch-to-switch 25Gb short-reach links
• High-density cabling environments requiring compact, vendor-compatible SFP28 connections

Key specifications

• Link type: Active optical cable (AOC) with integrated SFP28 connectors
• Nominal data rate: 25 Gigabit Ethernet per channel
• Length: 10 metres
• Connector form factor: SFP28-compatible
• Typical use: Short-range, single-mode/multimode fiber equivalent performance for rack-level interconnects
• Benefits: Low latency, low electromagnetic interference and reduced cable bulk compared with copper

How to use

Insert each SFP28 connector into the corresponding 25Gb SFP28 port on the network devices until it latches. Ensure devices are powered and configured to recognize AOC links; the cable requires no additional transceivers or field termination. Route the cable along rack pathways to avoid sharp bends and secure it with cable management accessories if needed. For initial deployment, verify link status and speed in the device management interface to confirm a stable 25Gb connection.

Recommendations

Use the cable for intra-rack and short inter-rack connections up to 10 m. Avoid tight bends and excessive pulling force during installation. Store and handle connectors with protective caps until insertion to prevent contamination. For mixed-vendor environments, verify SFP28 compatibility in device documentation and enable any required port settings for AOC operation.