Cable óptico activo InfiniBand CBO JNP-25G-AOC-3M-BO SFP28, 3 m, aqua, plata

InfiniBand Active Optical Cable CBO JNP-25G-AOC-3M-BO SFP28, 3 m, aqua, silver is a 3‑metre active optical link with SFP28 connectors designed for short‑reach high‑speed connections in data centre and enterprise network environments. The cable supports InfiniBand and SFP28‑compatible ports, delivering low latency and immunity to electromagnetic interference. Its aqua jacket and silver housing identify the cable for easy routing and maintenance while providing a plug‑and‑play connection between servers, switches and storage systems.

Advantages

This active optical cable combines the bandwidth of SFP28 connectivity with the low latency and signal integrity typical for InfiniBand links. As an optical solution, it eliminates susceptibility to electromagnetic noise and reduces crosstalk compared with copper alternatives. The 3 m length covers common rack and top‑of‑rack layouts without the need for additional transceivers, and the pre‑terminated SFP28 connectors simplify installation and replacement in operational environments.

Suitable for

Key specifications

How to use

Insert each SFP28 connector into the corresponding SFP28 port on your networking devices until the connector latches. Verify link status on both endpoints and ensure firmware or driver support for SFP28/AOC media if required by your equipment. Route the cable to avoid sharp bends and mechanical strain; maintain the recommended bend radius for active optical assemblies. For replacement, power‑down or follow hot‑swap procedures specified by your hardware vendor if necessary.

Recommendations

Use this 3 m InfiniBand active optical cable for direct, short‑reach connections in rack environments where reduced latency and immunity to electromagnetic interference are priorities. Avoid using the cable in outdoor or unprotected installations and keep it away from heat sources and excessive pulling force to preserve optical performance.