Cable óptico activo SFP+ 10G 3m CBO SFP-AOC-10G-3M — Cable AOC SFP+, 10 Gbit/s, 3 m

The SFP+ Active Optical Cable 10G 3m CBO SFP-AOC-10G-3M is a BlueOptics-compatible AOC designed to provide a 10 Gbps direct connection between SFP+ ports. At 3 metres in length, this active optical cable is intended for short-reach links in data centers, server racks and storage systems. It replaces separate transceivers and fiber assemblies to deliver a compact, low-latency connection with lower power consumption compared with discrete transceiver plus fiber combinations.

Advantages

This AOC integrates optical transceivers and a fixed cable in a single assembly to simplify installation and reduce component count. It supports 10 Gbps data rates over a 3 m reach, providing predictable performance for short interconnects. The active optical design reduces electrical power draw and heat at the host ports compared with separate SFP+ transceivers plus patch fiber. The compact SFP+ form factor ensures compatibility with standard SFP+ ports on switches, servers and storage equipment.

Suitable for

• Short-reach rack-to-rack connections in data centers
• Server-to-switch and switch-to-switch links within equipment cabinets
• Storage system interconnects requiring 10 Gbps bandwidth

Key specifications

• Interface: SFP+ plug-and-play active optical cable
• Data rate: 10 Gbps
• Length: 3 metres
• Cable type: active optical cable (integrated transceivers and fiber)
• Use case: short-reach interconnects for data center and rack environments

How to use

Insert each SFP+ connector into the corresponding SFP+ port on the two devices to be connected, ensuring the latch engages and the connectors are fully seated. No separate transceivers or patch fiber are required. Verify link status on the connected devices and confirm negotiated speed and link integrity through the network equipment management interface. If the switch or server requires specific firmware or a vendor compatibility setting for third-party AOCs, apply those settings according to the equipment vendor instructions.

Recommendations

Use the cable for short interconnect distances within racks or across adjacent racks. Avoid tight bends and maintain manufacturer's recommended bend radius for optical assemblies. When used in mixed-vendor environments, check compatibility notes from the host device manufacturer to ensure proper link detection and performance.