Cable óptico activo SFP+ CBO 10G 5m para IBM (SFP-AOC-10G-5M-IB-BO)

This SFP+ Active Optical Cable CBO 10G 5m for IBM (SFP-AOC-10G-5M-IB-BO) is a 10 Gigabit per second short-range fiber interconnect with SFP+ connectors designed for compatibility with IBM networking and server equipment. The 5-meter optical assembly provides a direct, low-latency link between switches, servers, or storage arrays while reducing electromagnetic interference and simplifying cable management compared with copper solutions. It is intended for data center and enterprise environments where reliable, power-efficient 10GbE connections are required over short distances.

Advantages

The active optical cable delivers 10Gb/s throughput with low power consumption and reduced heat generation compared to active copper cables. Optical transmission minimizes susceptibility to electromagnetic interference and crosstalk, improving signal integrity in dense rack environments. Its SFP+ form-factor enables hot-pluggable installation into compatible ports, simplifying upgrades and replacements without the need for transceivers and separate fiber patch cords. The sealed cable assembly provides consistent performance and a compact footprint for neat cable routing.

Suitable for

• Short-range 10 Gigabit Ethernet links between switches
• Direct server-to-switch or server-to-storage connections in racks
• Data center top-of-rack and middle-of-row cabling
• High-density network deployments where EMI immunity is important

Key specifications

• Data rate: 10 Gigabit per second
• Cable type: Active optical cable (AOC)
• Connector type: SFP+ on both ends (hot-pluggable)
• Length: 5 meters
• Typical use: Short-range data center interconnect
• Latency: Low, suitable for performance-sensitive applications
• Electrical characteristics: Low power consumption compared to equivalent copper assemblies

How to use

Insert each SFP+ connector into the corresponding SFP+ slot on the source and destination devices until it latches. Ensure both ports are powered and configured for 10GbE operation in the device interface settings. The cable is a single sealed assembly and requires no separate transceivers or fiber patch cords. Monitor link status indicators on connected equipment to confirm proper connection and negotiate link speed and duplex automatically if supported by the devices.

Recommendations

For reliable operation, route the cable to avoid excessive bending or mechanical stress on the connectors, and maintain the minimum bend radius specified by the manufacturer. Use in compatible SFP+ ports confirmed for the listed equipment family to ensure firmware and compatibility. In high-density racks, label both ends to simplify identification and inventory management.