Cable óptico activo SFP+ CBO AOC-S-S-10G-20M-BO 20 m (naranja)

Active Optical Cable SFP+ by BlueOptics, model AOC-S-S-10G-20M-BO, is a factory-terminated direct-attach optical link designed for SFP+ ports. This 20 m orange AOC provides 10 Gbps full-duplex connectivity using integrated transceivers and multimode fiber within a single fixed assembly. The cable aims to deliver low latency and immunity to electromagnetic interference for short-reach interconnects between servers, switches and storage systems in data centers and network rooms.

Advantages

The SFP+ Active Optical Cable eliminates the need for separate transceivers and fiber patching by combining optical transceivers and fiber in one pre-terminated assembly, simplifying deployment and reducing component count. Its optical design reduces sensitivity to electromagnetic interference and crosstalk compared with copper alternatives, while the 20 m length extends reach beyond typical passive copper SFP+ direct-attach cables. The fixed-assembly approach ensures consistent optical performance and easy hot-plug installation into standard SFP+ ports.

Suitable for

• 10 Gbps server-to-switch and switch-to-switch links in data centers
• Short-reach storage area network (SAN) connections and uplinks
• Network room cabling where EMI immunity is required
• High-density rack interconnects requiring reduced cable bulk

Key specifications

• Connector type: SFP+ form-factor plugs on both ends
• Data rate: 10 Gbps full duplex
• Length: 20 meters
• Transmission medium: active optical assembly with multimode fiber
• Color: orange (for easy identification of OM class or channel)
• Plug-and-play: hot-pluggable into SFP+ ports (vendor compatibility dependent)
• Low latency optical transmission suitable for short-reach interconnects

How to use

Install the cable by inserting each SFP+ plug into the corresponding SFP+ port until the latch engages, following the host equipment manufacturer's guidance for hot-plugging. Verify link status on connected devices and configure network interfaces as required for 10 Gbps operation. Avoid excessive bending of the cable near the assembly; follow recommended bend radii for multimode fiber and secure the cable to prevent strain on the connectors. If necessary, power-cycle or reset port settings after installation to ensure proper negotiation.

Recommendations

Use the 20 m AOC in short-reach applications inside data centers and network rooms where reduced electromagnetic interference and extended reach beyond passive copper DACs are needed. Confirm SFP+ compatibility with your network equipment vendor and observe fiber handling best practices—avoid tight bends, kinks, and physical damage to maintain optimal optical performance.