Cable óptico activo SFP+ CBO para Huawei SFP-AOC-10G-1M 10G 1m

Active Optical Cable CBO SFP-AOC-10G-1M for Huawei-compatible SFP+ ports provides a 1-meter fixed-length high-speed link that supports 10 Gbps data transmission. The cable integrates SFP+ connectors with an active optical transceiver assembly to deliver reliable short-reach connections between network switches, servers and storage devices while minimising electromagnetic interference and heat compared with equivalent copper DACs.

Advantages

This 10G active optical cable offers low insertion loss and stable signal integrity across its 1 m span, enabling low-latency data transfer in dense networking environments. The plug-and-play SFP+ modules require no additional configuration and are hot-pluggable, which simplifies installation and replacement. Its optical design reduces susceptibility to electromagnetic interference and allows for lighter, more flexible cabling routing in racks and corridors.

Suitable for

• Short-distance 10 Gbps interconnects between network switches
• Direct links from servers to top-of-rack or aggregation switches
• Storage area network (SAN) uplinks and backup interfaces
• High-density rack environments where flexible, low-profile cabling is needed

Key specifications

• Data rate: 10 Gbps
• Form factor: SFP+ connectors on both ends
• Fixed cable length: 1 meter
• Transmission medium: active optical cable (single-mode/multimode optical assembly as implemented)
• Latency: minimal, suitable for low-latency applications
• Installation: hot-pluggable, plug-and-play
• Compatibility: designed for Huawei-compatible SFP+ ports

How to use

Insert each SFP+ connector into the corresponding SFP+ port on the network devices until the latch engages. Ensure both devices are powered according to their manufacturer instructions; the link will typically be negotiated automatically at 10 Gbps. Verify link status LEDs or management interfaces on the devices to confirm successful negotiation. To remove the cable, release the module latch and pull the connector straight out to avoid stressing the cable assembly.

Recommendations

For optimal performance, use within the specified 1 m distance and avoid sharp bends or tight cable ties that can stress the fibre assembly. Keep the connector dust caps on until installation and store the cable in a dry, clean environment when not in use. Verify firmware and compatibility notes for the host devices when integrating into existing networks.