Cable óptico activo SFP+ CBO para Zyxel SFP-AOC-10G-30M — 10 Gbit/s, 30 m

Active Optical Cable (AOC) CBO compatible with the Zyxel SFP-AOC-10G-30M form factor. This AOC supports a 10 Gbps data rate over a fixed 30-meter optical link and is intended for SFP+ ports in switches, servers and storage systems. The cable combines optical transceivers and a fixed fiber assembly in a single, pre-terminated unit that eliminates the need for separate transceivers and fiber patching for short-reach high-speed interconnects.

Advantages

The AOC provides 10 Gbps throughput with low latency and inherent electromagnetic immunity, reducing signal degradation and crosstalk in dense rack environments. As a pre-terminated active optical assembly it simplifies installation, minimizes connector loss and removes the need to manage separate fiber patch cords and SFP+ modules. The fixed 30 m length offers predictable link characteristics and helps maintain consistent performance across data center and server room runs.

Suitable for

• 10 Gbps links between top-of-rack switches and aggregation switches
• High-speed connections between servers and storage arrays within the same rack or adjacent racks
• Short-reach interconnects in data centers, server rooms and network closets

Key specifications

• Nominal data rate: 10 Gbps
• Link type: Active optical cable (integrated transceivers with fixed fiber)
• Length: 30 meters
• Port interface: SFP+ form factor for 10 Gbps SFP+ ports
• Signal properties: low latency, optical transmission with immunity to electromagnetic interference
• Typical applications: short-reach server, switch and storage interconnects

How to use

Install the AOC by inserting the SFP+ connector ends into compatible SFP+ ports on the source and destination devices. Ensure each device is powered down or hot-swap capable according to the equipment vendor’s guidance before insertion or removal. Verify link status through the device management interface and confirm the negotiated link speed is 10 Gbps. Avoid tight bends and kinks along the cable run to preserve the optical assembly; follow standard cable routing practices in racks and trays.

Recommendations

For reliable operation, use this AOC within its specified 30 m routing distance and avoid exposure to crushing forces, sharp bends, or excessive pulling. Confirm firmware and compatibility notes on the connected equipment: while the AOC is designed for SFP+ ports, verify that the network devices accept third‑party active optical assemblies if vendor compatibility locks are in place.