Cable óptico activo SFP+ CBO SFP-AOC-10G-20M para Fortinet 10G 20m

The BlueOptics SFP+ Active Optical Cable CBO SFP-AOC-10G-20M for Fortinet 10G 20m is a factory-terminated optical link that provides a 10 Gigabit per second connection over a 20-metre cable. Designed for SFP+ ports, this AOC enables direct, high-speed connections between switches, routers and servers in environments that require low latency and electrical isolation. The cable assembly integrates optics and connectors in a compact form factor for easy plug-and-play deployment in Fortinet and other compatible network devices.

Advantages

This active optical cable delivers 10 Gb/s data rate with consistent signal integrity across the full 20 m length while eliminating the need for separate transceivers and optical patch cords. The SFP+ form factor ensures hot-pluggable installation and interoperability with equipment that supports SFP+ AOCs. Electrical isolation provided by the optical medium reduces susceptibility to electromagnetic interference and ground-loop issues, and the factory-terminated design simplifies cabling management and reduces installation time.

Suitable for

• Data center top-of-rack and adjacent-rack connections
• High-bandwidth links between switches, routers and servers
• Short-reach interconnects requiring low latency and stable throughput
• Environments where electrical isolation and EMI immunity are important

Key specifications

• Data rate: 10 Gigabit per second (10 Gb/s)
• Connector type: SFP+ (dual-plug factory-terminated)
• Cable length: 20 metres
• Medium: Active optical cable with integrated transceiver electronics
• Typical use: Short-reach direct connections in networking equipment
• Form factor: Hot-pluggable SFP+ compatible module

How to use

Insert each SFP+ connector into the corresponding SFP+ port on the Fortinet device or compatible switch, router or server until it latches. Ensure both ends are fully seated and that the devices are powered and configured for 10 Gb/s operation. No additional transceiver modules or patch cords are required; the AOC is factory-terminated and ready for immediate use. Verify link status via the device management interface and check port LEDs to confirm an active 10 Gb/s connection.

Recommendations

Route the cable to avoid sharp bends and keep bend radius within the manufacturer’s guidelines to maintain optical performance. Use appropriate port configuration and firmware versions on network equipment to ensure compatibility. For rack cabling, secure the cable to reduce stress on connectors and maintain airflow in the rack environment.