Cable óptico activo SFP+ CBO SFP-AOC-10G-50M 10Gbit/s 50 m

SFP+ Active Optical Cable CBO SFP-AOC-10G-50M 10Gbps 50m is a factory-terminated SFP+ AOC that provides a single-cable solution for 10 Gigabit links up to 50 metres. The cable integrates SFP+ connectors on both ends and an optical fibre link inside the assembly, eliminating the need for separate transceivers and patch cords. It is intended for short-range, high-speed interconnects between switches, servers and storage devices in data centre and enterprise network environments, offering low latency and immunity to electromagnetic interference.

Advantages

This SFP+ active optical cable delivers a stable 10Gbps connection across a 50 m distance with the convenience of plug-and-play installation. Built-in optical transceivers reduce port density footprint compared with separate transceiver plus fibre assemblies, while the optical medium decreases susceptibility to electrical noise and crosstalk. The integrated design simplifies cabling management, reduces power consumption at endpoints compared with some copper alternatives, and supports low-latency data transmission suitable for high-throughput applications.

Suitable for

• Interconnects between top-of-rack and aggregation switches within data centres
• Server-to-switch uplinks in rack deployments
• Storage area network links requiring 10Gbps bandwidth
• High-density patching scenarios where reduced cable bulk is desirable

Key specifications

• Interface: SFP+ form factor with integrated optical cable
• Data rate: 10 Gigabits per second (10Gbps)
• Maximum reach: 50 metres over multimode optical fibre
• Media: Active optical cable with factory-terminated connectors
• Latency: low-latency optical transmission suitable for high-throughput traffic
• EMI performance: optical link provides immunity to electromagnetic interference
• Compatibility: designed for SFP+ host ports that support active optical cable modules

How to use

Install the cable by inserting each SFP+ connector into compatible SFP+ slots on your network devices until the module latches. Ensure both devices support SFP+ AOC modules and that firmware or driver settings do not restrict third-party optical accessories. Avoid bending the cable beyond recommended bend radius and secure the cable to prevent undue strain on connectors. If the link does not come up, verify port configuration, check for port disablement or speed/duplex settings, and inspect connectors for contamination.

Recommendations

Use this active optical cable for reliable short-reach 10Gbps links in controlled data centre and enterprise environments. Maintain proper cable routing, avoid tight bends, and keep connector endfaces clean. Confirm compatibility with switch and server vendors if device-level restrictions or specific firmware versions apply.