Cable óptico activo SFP+ CBO SFP-AOC-10G-5M para conexiones 10G, 5 m

The BlueOptics SFP+ Active Optical Cable CBO SFP-AOC-10G-5M for 10G connections, 5 m is a factory-assembled SFP+ direct-attach solution designed for short-reach 10 Gigabit Ethernet links. The 5 metre duplex AOC integrates optical transceivers and multimode fibre inside a thin, lightweight cable assembly that plugs directly into SFP+ ports without separate optical modules. It is intended for horizontal interconnects inside racks, rack-to-rack connections and blade server environments where reduced cable weight, lower power consumption and simplified installation are preferred.

Advantages

This Active Optical Cable delivers low-latency 10G connectivity with the convenience of a plug-and-play SFP+ form factor. The integrated optical link eliminates the need to buy and install separate transceivers and patch cords, reducing inventory and installation time. The fibre-based construction reduces weight and electromagnetic interference compared with copper equivalents and supports reliable signal integrity over the 5 m distance. Compatibility with standard SFP+ ports ensures straightforward hot-plug installation in compatible servers, switches and storage devices.

Suitable for

• Data center rack-to-rack 10 Gigabit Ethernet links
• Connections between switches and blade servers
• Short-reach storage area network (SAN) interconnects
• High-density patching where reduced cable bulk and weight are required

Key specifications

• Interface: SFP+ duplex plug-and-play optical assembly
• Data rate: 10 Gbps per link (10 Gigabit Ethernet)
• Length: 5 metres
• Optical medium: multimode fibre within active cable assembly
• Connector type: SFP+ compliant ends for direct insertion into SFP+ ports
• Latency: low latency suitable for server and switch interconnects
• Power: integrated active optics with lower power profile than many copper DACs at equivalent reach
• Mechanical: thin, lightweight cable jacket for high-density routing

How to use

Install the AOC by inserting each SFP+ end into the corresponding SFP+ ports on the two devices to be connected. The cable is hot-pluggable; ensure ports are compatible and powered according to device vendor guidelines. No separate transceivers or patch cords are required; the integrated optical modules will be recognized by equipment that supports standard SFP+ optics. Verify link status and speed on the connected devices after insertion and use standard network diagnostics to confirm proper operation.

Recommendations

Use the cable in short-reach applications up to the specified 5 m length and route it to avoid tight bends or sharp kinks that can stress the fibre assembly. For reliable operation, confirm SFP+ compatibility with your server, switch or storage vendor and keep firmware or driver recommendations in line with vendor guidance. Store and handle the cable by the connectors and avoid excessive pulling on the jacket to maintain long-term signal integrity.