Cable óptico activo SFP28 CBO BO272703Q1M 1 m — 25Gbps SFP28 AOC

CBO SFP28 Active Optical Cable BO272703Q1M is a 1 m SFP28 AOC engineered for 25Gbps direct connections between compatible SFP28 ports. The integrated active optical transceivers and factory-terminated fiber simplify cabling by combining transceiver and cable into a single assembly, providing a compact solution for short-reach high-speed links in data centers, switches and server environments. The cable supports the SFP28 form factor and is intended for use where low latency, stable throughput and reduced power compared with separate transceivers plus patch fiber are required.

Advantages

The Active Optical Cable design delivers consistent 25Gbps performance with lower electrical interference and reduced thermal load compared with copper alternatives. Integration of transceivers and optical fiber eliminates manual connector termination and reduces points of failure. The 1 m length offers a tidy, low-loss connection for adjacent racks or within equipment cabinets, helping to maintain predictable link characteristics and simplifying inventory management.

Suitable for

• Short-reach 25Gbps links between switches and top-of-rack servers
• Interconnects inside data center racks and between adjacent cabinets
• High-density switch ports where compact, low-power connections are needed

Key specifications

• Connector and form factor: SFP28 to SFP28 active optical cable
• Nominal length: 1 m
• Nominal data rate: 25 Gbps per channel
• Media type: factory-terminated multimode/mode-specified optical fiber with integrated active transceivers
• Typical reach: short-reach links suitable for rack/cabinet connections
• Latency: low latency optical transmission suitable for high-speed networking
• Power characteristics: reduced power consumption compared with discrete transceiver plus fiber assemblies

How to use

Insert each SFP28 connector into compatible SFP28 ports on the network devices until the latch engages, ensuring the devices are powered down or that hot-plugging is supported by the equipment. Verify link status via the host device management interface and confirm 25Gbps operation using switch or NIC diagnostics. Avoid tight bends and mechanical stress on the cable; route the cable within rack management features or cable guides to maintain bend radii and to reduce strain on connectors.

Recommendations

For reliable operation, use the cable for short-reach links within the same rack or between adjacent cabinets and follow equipment vendor compatibility guidance for SFP28 active optical cables. Inspect connector faces before insertion and keep the cable clean when not in use. Store the cable coiled with gentle loops and avoid exposure to liquids, excessive heat or sharp edges.