Cable SFP+ CBO AX-F0110-3D1CU0.5M-BL 0,5 m conector macho/conector macho 10 Gbit/s

The BlueOptics SFP+ Cable CBO AX-F0110-3D1CU0.5M-BL is a 0.5 meter direct-attach copper cable with male SFP+ connectors on both ends, engineered for short-range 10 Gbit/s interconnects. It provides a compact, low-latency physical link between SFP+ ports on switches, servers and storage systems, suitable for high-density rack and data center environments where space and signal integrity are important.

Advantages

This SFP+ direct-attach cable offers a simple and cost-effective way to establish 10 Gbit/s links without separate transceivers. The fixed copper assembly reduces power consumption compared with optical modules, while maintaining low latency and reliable signal transmission for short distances. Its 0.5 m length is optimized for connections inside rack units, minimizing excess cable and improving airflow and cable management.

Suitable for

• Short-range 10 Gbit/s connections between network switches
• Server-to-switch links in rack-mounted environments
• Interconnections between storage arrays and host adapters
• High-density patching within data center racks

Key specifications

• Interface: SFP+ male connector on both ends
• Maximum data rate: 10 Gbit/s
• Cable type: Direct-attach copper (DAC)
• Length: 0.5 meter
• Typical use: Short-range, rack-level interconnects
• Latency: Low, suitable for high-performance networking

How to use

Install the cable by inserting each SFP+ connector into the corresponding SFP+ port on your devices until the latch engages. Ensure both devices are powered and configured for 10 Gbit/s operation; the link should negotiate automatically if supported by the host hardware. For best results, avoid bending the cable tightly and verify port compatibility in device documentation before deployment.

Recommendations

Use this 0.5 m direct-attach SFP+ cable for in-rack connections where short reach, low latency and efficient cable management are priorities. Confirm firmware and hardware compatibility with your switch or server vendor to ensure link stability and full data-rate operation.