BlueOptics CBL-QSFP+AOC-10M-BO cable de fibra óptica InfiniBand 10 m conector macho/macho

The BlueOptics CBL-QSFP+AOC-10M-BO InfiniBand fibre optic cable 10m Male/Male is a 10‑metre active optical cable (AOC) with QSFP form‑factor connectors on both ends. Designed for short‑reach, high‑speed links, this cable implements QSFP to QSFP connectivity and supports multimode optical transmission for data centre and networking equipment that accept QSFP AOC modules.

Advantages

This BlueOptics AOC provides low-latency, high-bandwidth connectivity across a 10 m link while integrating optical transmitters and receivers into the cable ends to simplify installation and reduce transceiver inventory. The QSFP male‑to‑male interfaces follow industry MSA conventions for plug compatibility and allow use in systems that support compatible QSFP AOC modules. The multimode optical design is suitable for dense cabling runs in racks and between adjacent equipment rows.

Suitable for

Key specifications

How to use

Ensure both endpoints support QSFP AOC modules and that device firmware or vendor compatibility lists include support for compatible cables. Power down or follow hot‑swap guidelines of your equipment if required. Insert the QSFP connector into the device QSFP port until the latch engages; repeat on the opposite end. Verify link status on connected devices and confirm negotiated link speed and protocol. For rack routing, avoid sharp bends and keep the cable within manufacturer minimum bend radius specifications.

Recommendations

Use this 10 m QSFP AOC for short‑reach high‑bandwidth links inside data centres. Keep the cable away from sources of electromagnetic interference, avoid excessive pulling force, and store or route it to prevent tight bending. If compatibility questions arise, verify support with your hardware vendor prior to deployment.