CBO AOC Viavi SFP-AOC-10G-3M cable óptico activo 10G, 3 m, SFP+

CBO AOC Viavi SFP-AOC-10G-3M 10G Active Optical Cable, 3 m, SFP+ is a 3-metre active optical cable designed for direct 10 Gigabit Ethernet connections between SFP+ ports. The cable provides a fiber-based direct-connect link that eliminates the need for separate transceivers, offering lower power consumption and reduced heat generation compared with passive copper direct attach cables. It is intended for short-reach links inside racks and between adjacent racks in data centers, server rooms and network closets.

Advantages

The Active Optical Cable delivers reliable 10G connectivity with plug-and-play operation and no additional transceiver modules required. Its optical medium reduces electromagnetic interference and enables consistent signal integrity over the 3 m distance. Compared with copper alternatives, it lowers power draw and thermal output at the port, which can simplify cooling and power planning in dense installations. The SFP+ form factor ensures compatibility with equipment that supports standard SFP+ direct-attach optics.

Suitable for

• Interconnecting switches within the same rack
• Short links between adjacent racks in data centres
• Connecting servers to top-of-rack or leaf switches
• Storage array connections requiring 10 Gigabit links

Key specifications

• Interface: SFP+ to SFP+ (direct-connect active optical cable)
• Data rate: 10 Gigabit Ethernet
• Cable type: Active optical fiber
• Length: 3 metres
• Connector type: SFP+ module housings with integrated optical transceivers
• Typical reach: short-reach interconnects (within and between racks)
• Power and heat: lower port power consumption compared with copper DACs

How to use

Install the cable by inserting each SFP+ end into the corresponding SFP+ port on your devices until the latch engages. No separate transceivers or additional configuration is required for devices that support SFP+ direct-attach optics. After connection, verify link status and speed on both endpoints to confirm the 10G session is active. When removing the cable, release the SFP+ latches and pull straight out to avoid stressing the cable or connectors.

Recommendations

For reliable operation, use the cable within the specified 3 m range and route it to avoid sharp bends or tight bends below the manufacturer's minimum bend radius. Ensure connected equipment supports SFP+ active optical cables and verify compatibility lists if available. Keep the connectors free of dust and store unused ends with protective caps to maintain optical performance.