CBO InfiniBand Cable óptico activo QSFP-100G-AOC10M-BO 10 m QSFP28

The CBO InfiniBand Active Optical Cable QSFP-100G-AOC10M-BO 10 m QSFP28 is a 10‑meter active optical link with QSFP28 connectors designed for 100 Gbit/s InfiniBand and Ethernet interconnects. The cable provides optical transmission over a fixed assembly, offering electrical isolation and lower electromagnetic interference compared with equivalent copper assemblies. It is intended for use where a reliable, low‑latency 100G connection is required between compatible QSFP28 ports in racks, switches and servers.

Advantages

This active optical cable supports 100G data rates with QSFP28 interfaces, enabling high throughput and reduced signal attenuation over a 10 m distance. As an optical assembly, it eliminates ground‑loop and crosstalk issues common to copper and reduces susceptibility to electromagnetic interference. The integrated transceivers and optical fibers provide consistent performance without separate SFP/QSFP modules, simplifying cable deployment and maintenance in dense data center environments.

Suitable for

• Data center uplinks and switch-to-switch connections
• High-performance computing (HPC) cluster interconnects
• Server-to-switch 100G links in enterprise networks
• Environments requiring electrical isolation or reduced EMI

Key specifications

• Connector type: QSFP28 to QSFP28
• Rated data rate: 100 Gbit/s
• Length: 10 m
• Cable type: Active optical cable (AOC) with integrated transceivers
• Latency: low‑latency optical transmission suitable for InfiniBand and Ethernet
• Physical characteristics: fixed assembly with molded QSFP28 plugs

How to use

Install the cable by inserting each QSFP28 connector into the matching QSFP28 port on network equipment, ensuring proper alignment and fully seating the latch. No separate transceiver modules are required because the optical interfaces are integrated into the cable ends. Verify link status on both connected devices and confirm configuration for 100G operation in the switch or host adapters. When disconnecting, release the connector latch before withdrawing the plug to avoid damage.

Recommendations

Route the cable to avoid tight bends and maintain the manufacturer’s minimum bend radius; avoid sharp kinks and excessive tensile stress. Use in properly ventilated racks and keep optical connectors clean and free of dust when connecting. Verify compatibility with the target QSFP28 ports and firmware requirements of switches or host adapters before deployment.