BlueOptics MCA7J60-C007-BO MPO/UPC a 4×Duplex LC/UPC 7,5 m Multimodo OM4 50/125 µm LSZH 3,0 mm MPO de 8 hilos sin pines

BlueOptics MCA7J60-C007-BO MPO/UPC to 4×Duplex LC/UPC 7.5m is a multimode OM4 breakout patch cable designed for high-density fiber installations. The cable features an 8-core MPO (without pins) on one end and four duplex LC/UPC connectors on the other, enabling straightforward conversion from MPO trunk lines to standard LC duplex ports. With a 7.5 meter length and a 3.0 mm low-smoke, zero-halogen (LSZH) jacket in magenta, this cable is intended for data center trunking, patching and high-speed multimode links. A factory test report is supplied to document optical performance.

Advantages

This OM4 multimode breakout cable supports higher bandwidth and extended reach compared with lower grade multimode fibers, suitable for 10G/40G/100G multimode applications when used within system limits. The MPO/UPC to 4×Duplex LC/UPC configuration simplifies cross-connects between MPO backbone trunks and duplex LC equipment ports without additional patching hardware. The 3.0 mm LSZH jacket reduces toxic emissions in case of fire and the magenta color provides quick visual identification for OM4 multimode links. The supplied test report verifies insertion loss and continuity for reliable deployment.

Suitable for

Key specifications

How to use

Ensure that mating connectors and transceivers are clean and that the MPO keying and polarity match the intended channel layout before installation. Route the cable avoiding tight bends and excessive pulling forces; maintain the minimum bend radius recommended for 3.0 mm multimode cables. Plug the MPO end into the MPO trunk or cassette, and connect the four duplex LC connectors to the corresponding LC ports on patch panels or active equipment. Verify link continuity and insertion loss using appropriate test equipment or consult the supplied test report for baseline values.

Recommendations

Store and handle the cable in a dry environment and avoid kinking. Use dust caps on unused connectors to prevent contamination and perform regular inspection and cleaning of fiber endfaces with approved cleaning tools. Match the cable polarity and MPO pin-less configuration with your patching scheme and MPO cassettes to ensure correct channel alignment.