Módulo transceptor CBO QSFP Lumentum JDSU JQP-04SWAA2 25G 850nm

BlueOptics CBO QSFP Lumentum JDSU JQP-04SWAA2 25G 850nm is a hot-pluggable QSFP transceiver module designed for short-reach multimode fiber links. It supports a 25 Gbps data rate over 850 nm wavelength and is intended for integration into networking equipment with QSFP ports. The module provides a compact optical interface suitable for data center top-of-rack switches, aggregation switches and high-performance computing interconnects where short-distance, high-density optical connectivity is required.

Advantages

The module delivers 25G bandwidth in a QSFP form factor, allowing high-density deployment and easy upgrades in existing QSFP slots. Hot-pluggable design enables replacement or upgrades without powering down the host system. Operating at 850 nm with multimode fiber compatibility, it provides reliable short-reach transmission with low latency and predictable performance. The product follows Lumentum/JDSU specifications for interoperability with a range of transceivers and network devices.

Suitable for

Key specifications

How to use

Install the transceiver into a compatible QSFP port on the networking device until it latches securely. Connect the multimode fiber patch cable with an MPO/MTP connector between the transceiver and the corresponding port or cassette on the opposite end. Verify link status and data rate through the device management interface or LED indicators. For safe removal, follow the host equipment procedure to eject the transceiver and then disconnect the fiber cable.

Recommendations

To ensure optimal performance, use appropriate OM3 or OM4 multimode fiber and maintain clean fiber connectors. Verify compatibility with the host switch or router and consult equipment vendor guidelines for supported transceiver firmware or interoperability notes. Avoid exposing the transceiver to excessive dust, moisture or mechanical shock during installation and storage.