Módulo transceptor de red CBO 3FE50712BA-BO 10000 Mbit/s 10000 m

CBO 3FE50712BA-BO is an XFP network transceiver module designed for 10 Gbps fiber-optic links with a maximum reach of up to 10,000 m. Built for compatibility with devices that accept XFP form-factor modules, this transceiver supports high-speed, long-distance transmission over single-mode fiber and is intended for deployment in environments where stable 10,000 Mbit/s connectivity is required, such as data centers, carrier backbones and enterprise networks.

Advantages

The transceiver provides a standardized XFP interface for straightforward integration into compatible network equipment and delivers a 10,000 Mbit/s data rate with a proven long-reach capability. It is engineered for consistent optical performance and low error rates over extended fiber spans, reducing the need for intermediate repeaters or regenerators. The module’s industry-standard form factor and optical characteristics simplify replacement and spare-part management in operational networks.

Suitable for

• Long-distance 10 Gbps links between sites over single-mode fiber
• Data center uplinks and inter-switch connections
• Carrier and telecom backbone segments requiring stable high-bandwidth links
• Enterprise networks needing reliable 10,000 Mbit/s optical connectivity

Key specifications

• Form factor: XFP transceiver
• Nominal data rate: 10,000 Mbit/s (10 Gbps)
• Maximum link distance: up to 10,000 m over appropriate fiber
• Optical medium: single-mode fiber (SMF) for long-reach transmission
• Interface type: duplex optical

How to use

Install the XFP module into a compatible XFP port on the network device while the device is powered according to the equipment manufacturer’s guidelines. Ensure fiber patch cables and connectors are clean and matched to single-mode specifications before mating. After insertion, verify that the host device recognizes the module and that link status and signal indicators report normal operation. Configure the network interface settings on the host device as required for your network, including speed, duplex and any optical diagnostics or alarms the equipment offers.

Recommendations

To maintain optical performance, handle the transceiver by the housing, avoid touching the optical connector endfaces, and keep protective caps on when the module is not in use. Use appropriate ESD precautions during installation and follow the fiber vendor’s cleaning procedures for connectors. Verify compatibility with the target device’s supported XFP specifications before deployment.