Módulo transceptor SFP+ CBO 331-5310-BO 10 Gbit/s 1310 nm

The SFP+ Transceiver Module CBO 331-5310-BO 10 Gbit/s 1310 nm is a compact, hot-pluggable optical module designed for 10 Gigabit Ethernet links over single-mode fiber. It supports a nominal data rate of 10 Gbit/s at a transmission wavelength of 1310 nm and fits into standard SFP+ ports on switches, routers and servers. The module is intended for short- to medium-range connections and enables reliable optical uplinks, aggregation and storage area network (SAN) interconnects in data center and enterprise network environments.

Advantages

This SFP+ transceiver offers a small form factor and hot-pluggable operation that simplifies installation and replacement without powering down the host device. Operating at 1310 nm, it provides a balance between reach and dispersion tolerance suited to single-mode fiber links. The module is compatible with common SFP+ interfaces, delivers stable 10 Gbit/s throughput, and reduces copper cabling needs for higher-density and longer-distance connections.

Suitable for

• Data center uplinks between switches and aggregation layers
• Server-to-switch high-speed links
• Storage area network (SAN) interconnects
• Campus and enterprise backbone fiber segments
• Short- to medium-range single-mode fiber links

Key specifications

• Form factor: SFP+ (10 Gbit/s)
• Nominal data rate: 10 Gbit/s
• Wavelength: 1310 nm
• Optical interface: single-mode fiber
• Connector type: LC duplex
• Hot-pluggable: yes
• Typical application: short- to medium-range optical links (data center, aggregation, SAN)

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on your switch, router or server until it latches. Connect an LC duplex single-mode fiber cable ensuring correct transmit/receive orientation. Verify link status on the host device and configure relevant interface settings (speed/duplex or auto-negotiation, VLANs, or link aggregation) as required by your network topology. To remove the module, unlock the latch mechanism and pull the module straight out while observing ESD precautions.

Recommendations

Use this 1310 nm SFP+ module with single-mode fiber and LC duplex connectors. Ensure fiber cleanliness and proper connector seating to maintain signal quality. Match module specifications with host equipment compatibility lists and firmware requirements before deployment. Follow ESD handling and manufacturer guidelines for installation and removal to avoid damage.