Módulo transceptor SFP+ CBO 3HE04823AA-BO 10 Gbit/s 1310 nm

The BlueOptics SFP+ Transceiver Module 3HE04823AA-BO is a compact hot-pluggable optical interface designed for 10 Gbit/s links at a wavelength of 1310 nm. Intended for use in data centers and enterprise networks, this SFP+ module supports 10 Gigabit Ethernet and Fibre Channel transport over single-mode fiber, enabling reliable high-speed connections between switches, routers and servers while allowing straightforward upgrades and maintenance without system downtime.

Advantages

This SFP+ transceiver provides a compact form factor with hot-swappable capability, reducing service interruptions during installation or replacement. Operating at 10 Gbit/s and 1310 nm, it is suitable for medium to long distance single-mode fiber links and offers compatibility with standard 10G network equipment. The module’s standardized SFP+ footprint simplifies inventory and deployment across racks and chassis-based systems.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and aggregation devices
• Server-to-switch connections in data center topologies
• Fibre Channel storage area network links at 10 Gbit/s
• Network upgrades where compact, hot-pluggable optics are required

Key specifications

• Data rate: 10 Gbit/s
• Optical wavelength: 1310 nm
• Form factor: SFP+ (hot-pluggable)
• Fiber type: Single-mode fiber (SMF)
• Typical application: 10 Gigabit Ethernet, Fibre Channel
• Interface: Duplex LC connector compatible

How to use

Insert the module into an available SFP+ slot on a compatible switch, router or server while the system is powered on, taking care to align the module with the slot rails. Connect single-mode fiber using a duplex LC patch cable and ensure proper cable routing and strain relief. After insertion, verify link status and negotiated speed in the device management interface or LEDs. Follow the host device vendor’s guidance for any required configuration or firmware compatibility checks.

Recommendations

Use this transceiver in temperature- and dust-controlled environments; avoid excessive bending of single-mode fiber and ensure connectors are clean before mating. Confirm compatibility with the host device’s optics support list to ensure correct operation and interoperability.