Módulo transceptor SFP CBO SFP-1GLHXLC-T-BO 1,25 Gbit/s 1310 nm conector LCLC

CBO SFP-1GLHXLC-T-BO is a Small Form-factor Pluggable (SFP) transceiver module designed for single-mode fiber links operating at 1310 nm. The module supports a 1.25 Gbps data rate and uses an LCLC duplex connector for fiber pairs. It is intended for installation in compatible switches, routers or fiber media converters and provides hot-swappable uplink capability for straightforward maintenance and network extension over long distances where 1310 nm operation is required.

Advantages

The SFP transceiver offers a compact SFP form factor that supports hot swapping, reducing downtime when replacing or upgrading modules. With 1310 nm wavelength and single-mode fiber compatibility, the module is suitable for extended reach links. The LCLC duplex connector ensures reliable duplex transmission, while the standardized electrical and optical interfaces allow simple integration into existing network equipment that supports SFP modules.

Suitable for

• Long-distance single-mode fiber uplinks between switches and routers
• Fiber links in enterprise campus or data center environments
• Replacing or upgrading existing 1.25 Gbps SFP ports
• Hot-swappable connections for minimal maintenance impact

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Data rate: 1.25 Gbps
• Operating wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Connector type: LCLC duplex
• Transmission mode: full-duplex optical link
• Hot-swappable: yes

How to use

Insert the SFP transceiver into a compatible SFP slot on your switch, router or media converter until it latches. Connect single-mode duplex fiber with the LCLC connector to the transceiver, observing transmit/receive orientation. Ensure the other end of the fiber is terminated with a matching single-mode transceiver or patch panel. After insertion, verify link status and speed via the network device's management interface and monitor optical signal levels to confirm proper operation.

Recommendations

Use single-mode fiber cables and clean LCLC connectors before insertion to maintain signal quality. Confirm compatibility with your network equipment's supported SFP modules and check optical power budget and link distance for 1310 nm operation to ensure reliable performance.