BlueOptics QSFP-H40G-CU3M-BL cable de fibra óptica InfiniBand 3 m conector macho/conector macho

The BlueOptics QSFP-H40G-CU3M-BL is a 3 m high-speed direct attach cable (DAC) with QSFP male connectors on both ends. Designed for short-reach connections in racks and between adjacent racks, this 40GBase-CR4-compatible twinax cable supports Ethernet, FCoE, Fibre Channel and InfiniBand data transport at up to 40 Gbit/s over a 3 metre distance. The cable uses 30 AWG twinax conductors and an MSA-compliant QSFP-to-QSFP interface to ensure mechanical compatibility with hardware platforms that accept QSFP 40G DACs.

Advantages

This passive twinax cable provides low latency and low power consumption, and its passive design requires no active electronics in the cable itself. The robust construction and use of quality components deliver reliable electrical performance for short-distance links and contribute to extended service life in demanding data center environments. The cable is compatible with a wide range of switches, routers and storage systems that support 40G QSFP direct attach cables.

Suitable for

• Interconnects inside server racks and between adjacent racks
• High-speed uplinks between switches and aggregation devices
• Storage array connections and SAN uplinks using Fibre Channel or FCoE
• Low-latency InfiniBand links and compute cluster cabling

Key specifications

• Length: 3 metres
• Connector type: QSFP male to QSFP male
• Data rate support: up to 40 Gbit/s (40GBase-CR4)
• Cable type: passive twinax copper (30 AWG)
• Transmission media: electrical direct attach for short-range links
• Standard compliance: MSA-compliant QSFP form factor

How to use

Install the cable by inserting each QSFP connector into the corresponding QSFP ports on your networking devices until the connector latches. Ensure both devices support passive 40G DAC twinax connections and that firmware or platform compatibility is met. Route the cable within racks or between adjacent racks to avoid sharp bends and excessive strain; maintain the manufacturer’s minimum bend radius. No additional power or configuration is required on the cable itself—link negotiation and protocol handling occur on the connected devices.

Recommendations

For optimal performance, use this 3 m passive QSFP twinax cable for short-reach connections only. Verify device compatibility and firmware support before deployment, keep cable runs within recommended distances, and avoid tight bends or mechanical stress to preserve signal integrity and service life.