BlueOptics SFP-AOC-10G-25M-IX-BO cable de fibra óptica InfiniBand SFP+ 25 m conector/conector

The BlueOptics SFP-AOC-10G-25M-IX-BO is a 25-metre SFP+ active optical cable engineered for 10 Gigabit-class data links. With SFP+ male connectors on both ends, the cable is intended for direct connection between SFP+ ports in servers, switches and storage systems. Its optical design reduces electromagnetic interference and supports reliable, low-latency transmission over a 25 m link length, suitable for short to medium fabric interconnects in data centers and enterprise network racks.

Advantages

This active optical cable offers a lightweight, flexible alternative to copper twinax for 10 Gb/s links, delivering lower attenuation over the 25 m distance and immunity to EMI. The SFP+ form-factor connectors allow hot-pluggable installation into standard SFP+ ports without additional transceivers. The integrated optics provide consistent performance with reduced power dissipation compared to separate transceiver-plus-cable solutions, and the cable construction supports tidy cable management in rack environments.

Suitable for

• Connecting SFP+ ports between switches and routers within data centre racks
• Server-to-switch connections for high-speed compute and storage networks
• Aggregation links and top-of-rack interconnects requiring 10 Gbps throughput
• Environments where EMI immunity and reduced weight are needed compared to copper

Key specifications

• Interface: SFP+ male connectors on both ends
• Link length: 25 metres
• Supported data rate: 10 Gbps (SFP+ class)
• Cable type: Active optical cable (AOC)
• Transmission medium: Fibre optics (integrated transceivers)
• Typical use: Short- to medium-reach intra-rack and inter-rack links

How to use

Insert each SFP+ connector into the corresponding SFP+ port on the devices to be connected, ensuring the connectors latch fully to the port. No separate SFP+ transceiver modules or fibre patch leads are required. After physical installation, verify link status on both devices and confirm negotiated speed of 10 Gbps. Route the cable to avoid tight bends and mechanical stress; observe vendor guidelines for minimum bend radius and secure the cable to maintain airflow and rack organisation.

Recommendations

Verify device compatibility with SFP+ active optical cables and check firmware or vendor interoperability notes when connecting equipment from different manufacturers. Maintain clear access for service and avoid exceeding recommended bend radius to preserve optical performance over the cable's service life.