SFP AOC Cable Óptico Activo CBO 10G 30M

BlueOptics SFP AOC Active Optical Cable CBO 10G 30M is a factory-terminated duplex optical link that provides 10 Gigabit Ethernet connectivity over a 30-metre distance. Designed for direct connection to SFP+ ports, this active optical cable integrates optical transceivers and fiber in a single flexible assembly, eliminating separate transceiver installation and reducing cable weight and electromagnetic interference compared with copper alternatives. The cable supports low-latency data transfer for switch-to-switch, server-to-switch and appliance interconnects in data centres and enterprise networks.

Advantages

The AOC design offers plug-and-play installation with pre-terminated SFP+ connectors, ensuring consistent optical performance and simplified deployment. Because the link is optical, it is immune to EMI and provides stable signal integrity across the full 30 m length. The integrated active components maintain the required electrical-to-optical conversion and offer lower power consumption and heat dissipation than external transceivers with separate copper cabling. The cable’s lightweight, flexible construction reduces rack cabling bulk and eases handling during installation or reconfiguration.

Suitable for

• Data centre top-of-rack and end-of-row switch interconnects
• High-performance server-to-switch links
• Storage area network (SAN) and appliance connectivity
• Short-reach 10GbE backbone connections within equipment rooms

Key specifications

• Connector type: SFP+ form-factor plug (duplex)
• Data rate: 10 Gigabit Ethernet
• Maximum link length: 30 metres over duplex multimode or specified optical fibre
• Transmission medium: Active optical cable (integrated optical transceivers and fiber)
• Latency: low-latency optical transport suitable for high-speed switching
• Electromagnetic immunity: immune to EMI and RFI typical of optical links
• Construction: flexible, lightweight cable assembly with factory-terminated ends

How to use

Install the cable by inserting the SFP+ connectors into compatible SFP+ ports on the devices to be connected, ensuring proper alignment and a secure latch. Verify that the host ports support passive or active AOC modules as required by the switch or server vendor. After insertion, check device diagnostics or link indicators to confirm a successful 10G link. Avoid sharp bends and excessive pulling force during routing; observe the manufacturer’s minimum bend radius and cable handling guidelines for reliable optical performance.

Recommendations

Use the cable for intra-rack and short inter-rack connections up to 30 m in length. Confirm compatibility with your network equipment SFP+ port specifications and firmware; consult device documentation if link training or module identification is required. For permanent installations, manage cable slack and secure routing to prevent stress on connectors and to maintain predictable optical performance.