BlueOptics SFP28-AOC-25M-AT-BO cable óptico activo SFP28, 25 m, aqua, conector macho-conector macho

The BlueOptics SFP28-AOC-25M-AT-BO is a 25 m active optical cable with SFP28 connectors at both ends, designed for 25 Gbps links in data centre and telecommunication environments. This male-to-male AOC uses multi‑mode optical transmission over a pre‑assembled cable in aqua colour and is intended for short‑reach interconnects between servers, switches and storage equipment. The lightweight design (approx. 0.15 kg) simplifies routing in racks and cabinets while providing an integrated transmitter and receiver at each end for optical signal transfer.

Advantages

The active optical cable delivers 25 Gbit/s data rates on a 25 m reach without the need for discrete transceivers and patch cords, reducing insertion points and potential signal loss. Compliance with SFP28 MSA‑defined electrical and mechanical interfaces ensures interoperability with systems that support SFP28 AOC modules. Integrated digital diagnostics (DDM/DOM) support real‑time monitoring of supply voltage, TX bias current, TX output power, RX input power and temperature where supported by host hardware. The pre‑terminated construction reduces installation time and susceptibility to electromagnetic interference compared with copper solutions.

Suitable for

• Short‑reach switch-to-switch connections in data centres
• Server-to-switch interconnects in rack environments
• Storage array connectivity and SAN links
• High‑speed fiber‑optic uplinks within telecom racks

Key specifications

• Data rate: up to 25 Gbit/s
• Cable length: 25 m
• Connector type: SFP28 to SFP28 (male-to-male)
• Optical medium: multi‑mode fiber with active transceivers integrated
• Color: aqua
• Approximate weight: 0.15 kg

How to use

Insert each SFP28 connector into the corresponding SFP28 port on the devices to be linked, ensuring the connectors click into place and that the host devices support SFP28 AOC modules and the 25 Gbit/s protocol in use. If the equipment supports digital diagnostics, enable or access the DDM/DOM interface through the host management software to monitor link parameters. Route the cable through the rack or conduit without sharp bends and secure it to avoid strain on the connectors.

Recommendations

Avoid tight bends and excessive pulling force during installation; maintain the cable within the manufacturer recommended bend radius and verify host compatibility with SFP28 AOCs before deployment. For critical links, confirm DDM/DOM readings after installation and perform periodic checks to ensure stable power and temperature conditions.