Transceptor CBO SFP-10G-RJ45 compatible cable de cobre módulo 10G

The Transceiver CBO SFP-10G-RJ45 compatible Copper Wire 10G module is a hot-pluggable SFP+ transceiver designed to deliver 10 Gigabit Ethernet over standard copper (RJ45) cabling. Compatible with equipment that accepts SFP+ modules, this copper 10G transceiver is intended for short-reach connections between switches, servers and other network devices where a 10G copper link is required. It supports straightforward installation and replacement without powering down the host device, simplifying maintenance and upgrades in enterprise and data center environments.

Advantages

This compatible 10G SFP+ copper transceiver provides 10 Gigabit performance over existing RJ45 copper infrastructure, avoiding the immediate need to replace cabling. Its SFP+ form factor enables hot-pluggable installation for minimal downtime. The module is suitable for standard short-distance links in rack and server environments and can be used to establish high-speed uplinks and server connections where fiber is not necessary or available.

Suitable for

• Data center uplinks and aggregation between switches
• Server connectivity within racks or adjacent racks
• Access layer links where 10G copper is preferred or required
• Quick replacements or upgrades to existing SFP+ ports

Key specifications

• Interface: SFP+ form factor with RJ45 copper port
• Data rate: 10 Gigabit Ethernet
• Cabling: Standard copper (Cat6/Cat6a/Cat7 as appropriate for 10G over short distances)
• Reach: Short-distance connections over copper cabling
• Hot-pluggable: Yes

How to use

Insert the SFP+ transceiver into an available SFP+ slot on a compatible switch, server or network device until it clicks into place. Connect a compatible RJ45 copper cable from the module to the target device. The host device should detect the module automatically; if necessary, verify link status and speed in the device management interface. For replacement, remove the existing module by pulling the release tab and pull the transceiver straight out before inserting the new one. Follow your equipment vendor’s guidelines for firmware and compatibility checks if any issues arise.

Recommendations

Use appropriate category-rated cabling and keep cable lengths within recommended limits for 10G copper to ensure reliable performance. Verify compatibility with the network equipment vendor when deploying third-party compatible transceivers and check device documentation for any required settings or firmware recommendations.