Transceptor CBO SFP-10G-ZR 10G módulo de fibra óptica

The Transceiver CBO SFP-10G-ZR 10G fiber optic module is a single-module SFP+ transceiver engineered for long-reach 10 Gbps data transmission over single-mode fiber. Designed for installation in SFP+ slots of switches, routers and optical transport equipment, this BlueOptics module delivers a compact form factor and consistent physical compatibility with standard 10G network ports. It is intended for enterprise and carrier environments where reliable high-speed links and extended reach are required.

Advantages

This 10G fiber optic module supports long-reach transmission while maintaining small form-factor compatibility with SFP+ ports, allowing straightforward integration into existing network hardware. It provides stable throughput at 10 Gbps, low latency suitable for high-bandwidth applications, and is manufactured to meet industry optical interface standards for interoperability with a wide range of single-mode fiber systems. The compact design and standard connector interface simplify installation and replacement.

Suitable for

• Long-distance 10 Gbps links between switches and routers
• Metropolitan and long-haul enterprise network backbones
• Carrier-grade optical transport and aggregation equipment
• Data center uplinks and inter-rack connections over single-mode fiber

Key specifications

• Data rate: 10 Gbps
• Form factor: SFP+ (hot-pluggable)
• Fiber type: single-mode fiber (SMF)
• Transmission reach: long-reach (ZR-class optical performance)
• Connector type: LC duplex
• Optical interface: single-wavelength long-distance transceiver
• Operating temperature: industry-standard commercial/extended ranges (refer to vendor datasheet for exact values)

How to use

Install the SFP+ module into an available SFP+ slot on your switch, router or optical transport device while the host port is powered according to the equipment vendor instructions. Connect LC duplex single-mode fiber patch cords to the module's optical ports, ensuring correct Tx/Rx alignment. After physical installation, verify link status and configuration through the host device management interface and apply any required port settings such as speed, duplex, or optical diagnostics. If necessary, consult the network equipment compatibility list and perform firmware or driver updates recommended by the hardware vendor.

Recommendations

Use certified single-mode LC patch cords and maintain clean connector endfaces to ensure optimal optical performance. Match the transceiver to compatible SFP+ ports and verify support for long-reach modules in the host device. Monitor link parameters and optical diagnostics to detect degradation, and follow standard ESD precautions during handling and installation.