Transceptor CBO SFP-10G-ZR fibra óptica 10G 850nm

The Transceiver CBO SFP-10G-ZR Fiber Optic 10G 850nm from BlueOptics is a compact, hot-pluggable SFP module that supports 10 Gbps data transmission at an 850 nm wavelength. It is intended for use in compatible switches, routers and optical links to enable short-reach fiber connections. The module provides a standardized interface for integrating 10G fiber connectivity into data center uplinks, server interconnects and enterprise network segments that require reliable high-speed links.

Advantages

This 10G SFP transceiver offers a small form factor with hot-pluggable operation, allowing replacement or upgrades without powering down equipment. It supports a 10 Gbps line rate and operates at an 850 nm wavelength suitable for short-reach multimode fiber links. The module is compatible with standard SFP ports on network equipment that accept this form factor and provides a straightforward solution for adding fiber connectivity where copper ports are not available or practical.

Suitable for

• Data center uplinks between switches and aggregation devices
• Server-to-switch interconnects requiring 10G fiber links
• Enterprise campus connections over short-reach multimode fiber
• Upgrading switch ports to support 10 Gbps fiber

Key specifications

• Form factor: SFP (small form-factor pluggable)
• Data rate: 10 Gbps
• Wavelength: 850 nm
• Optical type: fiber optic, intended for short-reach multimode links
• Hot-pluggable: yes

How to use

Insert the module into a compatible SFP port on a switch, router or other network device while the host is powered according to the device manufacturer's guidance. Connect the appropriate multimode fiber cable with matching connectors to the transceiver and secure connections at both ends. After installation, verify link status and configure the host interface for 10 Gbps operation in the device management interface. When removing or replacing the module, follow electrostatic discharge (ESD) precautions and hot-swap procedures recommended by the equipment vendor.

Recommendations

Use the transceiver with compatible multimode fiber and matching connector types, keep fiber ends clean to ensure optimal performance, and confirm compatibility with the network equipment vendor's supported SFP list before deployment.