Transceptor de fibra óptica SFP-10G-LRM, CBO, conexión multimodo 10G

The BlueOptics SFP-10G-LRM Fiber Optic Transceiver is a compact, hot-pluggable 10G SFP+ module designed for multimode fiber links. It supports 10 Gigabit Ethernet over multimode fiber for short-reach connections and is intended for use in network switches, routers and servers with SFP+ ports. The module provides reliable optical connectivity for data center uplinks and enterprise interconnects where space efficiency and straightforward installation are required.

Advantages

This transceiver delivers 10 Gbps data transmission over multimode fiber with a small form-factor that fits standard SFP+ slots. It supports hot-pluggable operation for easy replacement or upgrades without powering down equipment. The BlueOptics design emphasizes compatibility with common SFP+ interfaces and straightforward integration into existing network hardware. Low power consumption and a compact footprint make it suitable for dense rack deployments.

Suitable for

• Short-reach 10 Gigabit Ethernet links in data centers
• Switch-to-switch and switch-to-server uplinks using multimode fiber
• Enterprise network aggregation and campus backbone segments

Key specifications

• Form factor: SFP+ (small form-factor pluggable, 10G)
• Media type: Multimode fiber
• Data rate: 10 Gbps
• Reach: optimized for short-reach multimode links
• Connector type: LC duplex compatible
• Power characteristics: low power consumption suitable for dense installations
• Operating environment: designed for standard telecom/datacom ambient conditions

How to use

Insert the SFP-10G-LRM transceiver into an available SFP+ slot on a compatible switch, router or server until it clicks into place, then secure the fiber patch cords to the module's duplex LC connector. Ensure the device and the connected port are powered and configured for 10G operation in the host equipment's management interface. For link validation, check port LEDs or management software for signal and link status. Remove the module by releasing the latch and gently pulling it from the slot when the host device is powered down or when hot-swap procedures recommended by the equipment vendor are followed.

Recommendations

Use single-mode and multimode fibers according to their specifications; for this module, use appropriate multimode fiber cabling and LC duplex connectors. Keep optical connectors clean and use dust caps when the transceiver is not connected. Verify compatibility with the host device and configure link settings to match 10G multimode operation. For best performance in data center or enterprise environments, pair the transceiver with multimode patch panels and properly rated fiber patch cords.