Transceptor de fibra óptica SFP+ CBO SFP-10G-BX-U 10G 1310nm

The SFP+ Fiber Optic Transceiver CBO SFP-10G-BX-U 10G 1310nm is a 10 Gigabit SFP+ module designed for single-wavelength transmission at 1310 nm. Engineered for uplink and long-reach fiber links, this transceiver fits standard SFP+ ports and provides a reliable 10 Gbps optical interface for switches, routers and other optical equipment that accept SFP+ modules. It is intended for deployments in data centers, enterprise networks and carrier-grade infrastructures requiring high-bandwidth point-to-point connectivity.

Advantages

This transceiver supports 10 Gbps line rate over single-mode fiber at 1310 nm, providing long-reach connectivity with single-lambda operation. The compact SFP+ form factor enables flexible deployment in equipment with SFP+ cages and hot-pluggable operation for maintenance without system downtime. The module is compatible with standard SFP+ electrical and optical interfaces and is suited to mixed-vendor environments when devices support standard SFP+ optics.

Suitable for

• 10 Gbps uplink connections between switches and routers
• Long-reach single-mode fiber links in data centers
• Carrier and metropolitan network aggregation
• Optical equipment requiring SFP+ single-wavelength modules

Key specifications

• Data rate: 10 Gbps
• Optical wavelength: 1310 nm
• Form factor: SFP+ (hot-pluggable)
• Fiber type: Single-mode fiber (SMF)
• Transmission mode: Single-lambda, point-to-point

How to use

Insert the SFP+ module into a compatible SFP+ port until it clicks into place, taking care to observe proper electrostatic discharge (ESD) precautions. Connect single-mode fiber using appropriate LC connectors and ensure correct fiber polarity. After installation, verify link status on the host device and configure interface settings such as speed and duplex if required by the equipment. For hot-swap replacement, remove and insert modules while following the host device’s procedures to avoid traffic disruption.

Recommendations

Use quality single-mode fiber and clean LC connectors to maintain optical performance. Confirm host equipment supports 10 Gbps SFP+ optics and check link parameters after installation. Avoid bending the fiber beyond recommended radii and store unused modules with dust caps to protect optical interfaces.