Transceptor óptico SFP+ CBO SFP-10G-ZR 10Gbps 80km monomodo

The SFP+ optical transceiver CBO SFP-10G-ZR delivers 10Gbps optical connectivity over single-mode fiber with a maximum reach of up to 80 km. It is designed for installation in compatible SFP+ ports, offering a compact hot-pluggable form factor for straightforward deployment and replacement in network switches and routers. The module supports long-haul links suitable for data center interconnects, metro aggregation and carrier-grade transport where single-mode fiber is used.

Advantages

The transceiver provides a stable 10Gbps data rate and long-distance performance in a small SFP+ form factor, enabling space-efficient port density. Hot-pluggable capability allows replacement or upgrades without powering down equipment. Compliance with SFP+ electrical and optical interfaces ensures interoperability with a wide range of networking hardware that accepts compatible modules. Low power consumption and standardized optical parameters help maintain predictable link performance over extended fiber runs.

Suitable for

• Data center interconnects and server-to-switch links
• Metro aggregation and long-reach campus connections
• Carrier and service provider optical transport
• Network equipment upgrades where single-mode fiber is available

Key specifications

• Data rate: 10 Gbps
• Fiber type: single-mode fiber (SMF)
• Maximum reach: up to 80 km
• Form factor: SFP+ hot-pluggable
• Wavelength: typical ZR-class wavelength suitable for long-haul links
• Optical interface: LC duplex
• Power consumption: low-power SFP+ class

How to use

Insert the SFP+ module into a compatible SFP+ port on the network device until it clicks into place, taking care to handle the module by its housing and avoid touching the fiber connector. Connect LC duplex single-mode patch cables, observing correct transmit/receive orientation. After installation, verify link status and speed via the device management interface and ensure transmitter power and receiver sensitivity meet link budget requirements for the planned fiber distance. For removal, unlock any retention mechanism and gently pull the module from the port.

Recommendations

Use cleaned and certified single-mode fiber cabling and appropriate fiber spans to achieve the specified 80 km reach. Check compatibility with the host equipment firmware and supported optics list, and monitor temperature and optical power levels to maintain reliable long-haul links.