Transceptor SFP 10G CBO SFP-10G-ILR-BO 10 Gbit/s 1310 nm

CBO SFP-10G-ILR-BO is a BlueOptics SFP transceiver module that operates at 1310 nm and supports a 10 Gbps data rate. Designed for installation in SFP+ ports, the module is intended for optical uplinks in switches and routers and is suitable for short- to intermediate-reach single-mode fiber links. The transceiver provides a compact form factor and standard electrical and optical interfaces to enable straightforward integration into existing network equipment for high-speed data transmission.

Advantages

The module offers a standardized SFP+ form factor with a 10 Gbps throughput, compatible with common networking devices that accept SFP modules. Operating at 1310 nm enables reliable performance on single-mode fiber over intermediate distances. The design reduces the need for special configuration or additional components during installation, supporting plug-and-play replacement and network expansion without changes to the host hardware.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP-10G-ILR-BO module into an available SFP+ slot on the network switch or router until it clicks into place. Connect duplex single-mode fiber cables using the appropriate LC-style connectors, observing correct transmit/receive orientation. After physical installation, verify link status through the host device management interface and configure port settings such as speed and duplex if required by the equipment. Follow standard electrostatic discharge precautions when handling the transceiver.

Recommendations

Use on single-mode fiber links within the module's supported reach and ensure fiber connectors are clean before mating. Confirm compatibility with the host device's SFP+ port and firmware; if necessary, consult the equipment vendor for any module interoperability notes. Store unused modules in protective packaging to prevent contamination of the optical interfaces.