Transceptor SFP+ CBO FA-10Gb-Eth-SFP-LR 10 Gbit/s 1310 nm Fibra monomodo

CBO FA-10Gb-Eth-SFP-LR 10Gbps 1310nm Single-Mode Fiber is an SFP+ fiber-optic transceiver module engineered for 10 Gigabit Ethernet links over single-mode fiber. The small form-factor pluggable module supports a 1310 nm wavelength and provides long-reach optical transmission suitable for backbone, metro and data center interconnects. Designed for hot-swappable installation in compatible switches, routers and servers, the module delivers a compact, interoperable SFP+ interface for high-speed network uplinks and cross-connects.

Advantages

The transceiver offers a 10 Gbps line rate with single-mode optical operation at 1310 nm, enabling extended reach between network devices without external media converters. Its SFP+ form factor supports hot-swap replacement and reduces downtime during maintenance. The module is compatible with standard SFP+ ports, providing straightforward integration into existing network hardware while preserving rack space and power efficiency. Passive cooling and a compact footprint simplify installation and scalability.

Suitable for

• Long-reach 10 Gigabit Ethernet uplinks in data centers
• Backbone and metro fiber links between switches and routers
• Server to switch connections over single-mode fiber
• Network infrastructure requiring interoperable SFP+ transceivers

Key specifications

• Data rate: 10 Gbps
• Wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Form factor: SFP+ (small form-factor pluggable)
• Reach: long-reach optical transmission (typical single-mode distances)
• Interface: duplex LC optical connector
• Power characteristics: low-power SFP+ module (typical power consumption depends on host device)

How to use

Install the SFP+ transceiver into a compatible SFP+ port on a switch, router or server until it latches. Connect single-mode fiber with a duplex LC connector to the module, ensuring correct transmit/receive polarity. After physical installation, verify link status and speed on the host device and configure network settings as required by your environment. For hot-swap replacement, safely remove the module by releasing the latch and inserting the replacement while monitoring link negotiation.

Recommendations

Use single-mode patch cables with LC duplex connectors and ensure clean connector end-faces to maintain optical performance. Check compatibility lists of your network equipment for SFP+ modules and confirm transceiver settings such as speed and duplex in device firmware. Store unused modules in protective packaging to prevent contamination and mechanical damage.