Transceptor SFP+ CBO SFP-10G-ER 10G ER módulo de fibra óptica

The SFP+ transceiver CBO SFP-10G-ER 10G ER fiber optic module is a 10 Gigabit enhanced reach (ER) optical interface module designed for long-distance 10G fiber links. Compatible with a wide range of SFP+ slots and specifically tested for operation with Fortinet equipment, this module supports high-speed uplinks and interconnects in data centers and enterprise networks. It features a hot-pluggable SFP+ form factor for straightforward installation and replacement without powering down equipment.

Advantages

The module delivers extended-range 10G transmission over single-mode fiber with stable optical performance and low power consumption. Its SFP+ form factor ensures compatibility with standard 10G ports and simplifies spare-part management. Built for reliability in critical network environments, the transceiver provides consistent link stability and supports long-haul connectivity requirements while keeping installation and maintenance procedures simple.

Suitable for

• Long-distance 10 Gigabit links between switches and routers
• Data center uplinks and inter-rack connections over single-mode fiber
• Enterprise WAN links requiring extended optical reach
• Network equipment that supports SFP+ 10G optical modules, including Fortinet devices

Key specifications

• Interface: SFP+ hot-pluggable form factor
• Data rate: 10 Gigabit Ethernet
• Reach class: ER (extended reach) for long-distance single-mode fiber links
• Optical medium: single-mode fiber
• Typical power consumption: low-profile SFP+ class power usage
• Connector type: LC duplex
• Operating temperature range suitable for standard networking environments

How to use

Install the SFP+ transceiver into an empty SFP+ slot on compatible network equipment until it clicks into place, then connect single-mode fiber cables using LC duplex connectors. The module supports hot-plugging, so it can be inserted or removed while the host device is powered on; ensure transmit and receive fibers are connected correctly and observe link status indicators on the equipment to verify successful negotiation. Configure the connected network ports on the host device for 10G operation as required by your network setup.

Recommendations

Use high-quality single-mode fiber and maintain proper cable cleanliness to ensure optimal optical performance. Verify compatibility with the specific host device and firmware, update device firmware when necessary, and keep spare transceivers on hand for quick replacement in production environments.