Transceptor SFP+ CBO SFP-10G-ER-1310 10G 1310 nm

SFP+ transceiver CBO SFP-10G-ER-1310 10G 1310 nm is a 10 Gigabit optical module designed for SFP+ ports. Operating at a wavelength of 1310 nm, this transceiver provides a compact, hot-pluggable interface to create long-reach fiber connections suitable for data center uplinks, enterprise backbone links and metro network segments. The module supports single-mode fiber links and is intended to simplify upgrades and extend fiber connectivity without replacing existing SFP+ ports.

Advantages

The transceiver delivers 10 Gbps throughput over long distances with stable optical performance at 1310 nm, enabling reliable high-speed links. Its SFP+ form factor is compatible with standard SFP+ cages and supports hot-plug removal and insertion to minimize downtime during maintenance or upgrades. The module's compact size and low power profile reduce space and thermal impact in dense equipment racks, while optical interfaces avoid electromagnetic interference associated with copper cabling.

Suitable for

• Data center uplinks between switches and aggregation devices
• Enterprise backbone fiber connections across campus networks
• Metro and regional fiber links requiring long-reach 10G interfaces
• Upgrading existing SFP+ ports to support single-mode long-distance links

Key specifications

• Interface: SFP+ form factor, hot-pluggable
• Data rate: 10 Gigabit Ethernet (10 Gbps)
• Wavelength: 1310 nm
• Fiber type: Single-mode fiber (SMF)
• Optical connector type: LC duplex
• Reach: designed for long-reach single-mode links (long-distance)
• Power consumption: low-power SFP+ class module

How to use

Install the transceiver into an available SFP+ slot on a compatible switch, router or network device by aligning and gently inserting until the module clicks into place. Connect a single-mode LC duplex fiber cable to the optical port, ensuring correct transmit/receive orientation. Configure the network device for 10 Gbps operation as required and verify link status through device management interfaces. For safe removal, disable the port or shut down the interface if the device requires it, then press the release latch and pull the module out by its body.

Recommendations

Verify compatibility with the host device and consult device documentation for supported transceiver types and firmware requirements. Use quality single-mode LC duplex fiber and maintain clean fiber endfaces to prevent signal loss. Observe ESD precautions when handling the module and protect unused optical ports with dust caps to avoid contamination.