Transceptor SFP+ CBO SFP-10G-ER-1310 10G 1310 nm

The BlueOptics SFP+ Transceiver CBO SFP-10G-ER-1310 10G 1310 nm is an optical module designed for 10 Gigabit Ethernet links using a 1310 nm wavelength. Intended for SFP+ slots in switches, routers and server NICs that accept compliant transceivers, this module provides single-mode fiber transmission for long-reach uplinks and point-to-point connections. The module supports standard 10GBASE-ER signalling and is suitable for deployments that require stable, high-bandwidth optical connectivity across extended distances.

Advantages

This SFP+ transceiver offers 10 Gbit/s line rate on a 1310 nm wavelength with single-mode fiber compatibility, enabling extended reach compared with short-range optics. The small-form-factor pluggable design allows hot-swapping in SFP+ slots and minimizes space in dense rack environments. The transceiver adheres to common electrical and optical interfaces, facilitating integration into multi-vendor networks when used with compatible hardware.

Suitable for

• Long-reach 10 Gigabit Ethernet uplinks between aggregation switches and core devices
• Data center interconnects over single-mode fiber
• Enterprise backbone and campus fiber links requiring 10G optical ports
• Telecom access links and point-to-point fiber connections

Key specifications

• Data rate: 10 Gbit/s (SFP+ 10G)
• Optical wavelength: 1310 nm
• Fiber type: Single-mode fiber (SMF)
• Connector: LC duplex interface
• Form factor: SFP+ small form-factor pluggable
• Transmission type: 10GBASE-ER (long reach)

How to use

Insert the transceiver into a compatible SFP+ slot on the switch, router or network adapter while the host device is powered according to the vendor instructions for hot-pluggable optics. Connect the appropriate single-mode LC duplex fiber cable, ensuring correct TX/RX orientation and secure ferrule connection. Verify link status and speed via the host device management interface and confirm that the port is configured for 10G operation and the expected optical settings.

Recommendations

Use single-mode fiber with low insertion loss and follow fiber handling best practices: avoid tight bends, protect connectors from dust and contamination, and perform end-face inspection before mating. Confirm transceiver compatibility with the network device vendor and test links after installation to ensure optical power levels and link parameters meet system requirements.