Transceptor SFP+ CBO SFP-10G-ER-1310 10G 1310nm

The CBO SFP-10G-ER-1310 is an SFP+ optical transceiver module that supports 10 Gbps data rates over single-mode fiber using a 1310 nm wavelength. Designed for installation in compatible SFP+ ports, this BlueOptics module enables long-reach fiber links for uplinks and backbone connections where a 1310 nm interface is required. Typical environments include data center uplinks, metro and carrier networks, and enterprise backbone circuits requiring reliable high-speed connectivity.

Advantages

This SFP+ transceiver provides stable 10 Gbps performance with a single-mode 1310 nm optical interface, allowing extended reach compared with shortwave modules. Its compact SFP+ form factor supports hot-pluggable installation into standard network equipment, reducing downtime during upgrades or replacements. The module is compatible with common SFP+ ports and is intended to offer a predictable fiber link behavior in point-to-point and trunking applications.

Suitable for

• Data center uplink and aggregation links
• Carrier and metro network long-reach connections
• Enterprise backbone and campus fiber runs
• High-speed point-to-point fiber links between switches and routers

Key specifications

• Data rate: 10 Gbps
• Wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Form factor: SFP+
• Optical interface: 1310 nm transmitter and receiver for long-reach links
• Hot-pluggable: yes

How to use

Install the SFP+ transceiver into a compatible SFP+ slot on your switch, router or network interface card until it clicks into place. Connect a single-mode fiber patch cord with appropriate connectors to the module’s optical interface, observing correct transmit/receive orientation. Verify link status and speed on the host device and ensure wavelength and fiber type match at both ends of the link. For equipment that enforces vendor checks, confirm firmware or compatibility settings as required by the network device.

Recommendations

Use certified single-mode fiber and clean connectors to maintain signal integrity. Avoid bending the fiber beyond its minimum bend radius and verify both ends of the link use compatible 1310 nm transceivers. When replacing or installing modules, follow the host equipment vendor’s guidelines for transceiver provisioning and monitoring.