Transceptor SFP CBO SFP-1GLSXLC-T-BO 100 Mbit/s LC multimodo 2000 m

The SFP transceiver CBO SFP-1GLSXLC-T-BO provides 100 Mbit/s fiber connectivity through an LC connector for multimode links up to 2000 m. Designed for compatibility with switches, routers and media converters that accept standard SFP modules, this compact transceiver enables extension of network segments over fiber to reduce electromagnetic interference and simplify cabling. The module supports single-channel 100 Mbit/s data transmission on multimode fiber and is suitable for deployments in campus, office and industrial network environments where fiber reach and reliable physical separation are required.

Advantages

The module offers a compact SFP form factor that fits into standard SFP slots, allowing flexible port population and hot-swap replacement. With multimode LC connectivity and a 2000 m nominal reach it supports longer runs than many copper alternatives and helps minimize cable bulk. The transceiver provides stable 100 Mbit/s link performance and reduces susceptibility to electrical noise while maintaining compatibility with common network equipment that supports SFP optics.

Suitable for

• Extending Ethernet segments between buildings on multimode fiber
• Connecting switches, routers or media converters with SFP ports
• Replacing copper uplinks to avoid EMI or ground-loop issues
• Small and medium campus or office backbone links up to 2000 m

Key specifications

• Data rate: 100 Mbit/s
• Connector type: LC
• Fiber type: multimode fiber (MMF)
• Nominal reach: up to 2000 m on multimode fiber
• Form factor: SFP (hot-pluggable)
• Operating wavelength: suitable for multimode transmission (850 nm class)
• Typical applications: Ethernet links, device uplinks, media conversion

How to use

Insert the transceiver into an available SFP slot on a compatible switch, router or media converter while the host device is powered or following manufacturer guidelines for hot-swap installation. Connect an LC-terminated multimode fiber patch cable between this transceiver and the remote fiber transceiver or patch panel. Verify link status and configure the host port for 100 Mbit/s operation if required by the equipment; many systems will auto-negotiate or detect the module type automatically. Follow standard fiber handling practices and observe connector cleanliness to ensure reliable signal transmission.

Recommendations

To ensure optimal performance, use multimode fiber and LC connectors rated for the specified reach, keep connectors clean and use appropriate attenuation or transceiver settings when mixing fiber types or linking across equipment with differing specifications. Check host-device compatibility with 100 Mbit/s SFP modules and consult device documentation for any configuration steps or firmware requirements.