Boquilla hotend Flashforge Creator 4 Left Nozzle Assembly-HT 0,4 mm

The Flashforge Creator 4 Left Nozzle Assembly-HT (0.4mm) is a replacement hotend nozzle designed for use with the Flashforge Creator 4 3D printer. Produced for high-performance printing, this 0.4 mm nozzle supports precise extrusion and is intended to maintain consistent print quality across different filament types. It is supplied as the left-side nozzle assembly and is compatible with Flashforge Creator 4 machines.

Advantages

This left nozzle assembly provides accurate 0.4 mm extrusion for fine detail and consistent layer lines. Built to fit the Creator 4, it simplifies maintenance and replacement of the printer's hotend components. The HT designation indicates suitability for higher-temperature printing compared to standard nozzles, helping to handle a wider range of materials.

Suitable for

• Precision parts and detailed models requiring 0.4 mm nozzle diameter
• Use on Flashforge Creator 4 printers as the left-side hotend
• Printing with higher-temperature filaments where HT-rated components are recommended

Key specifications

• Model: Left Nozzle Assembly - HT (0.4 mm)
• Compatibility: Flashforge Creator 4
• Nozzle diameter: 0.4 mm
• Manufacturer part number (MPN): 20002953001
• EAN: 6971940408017
• Country of origin: China

How to use

Power off and cool the printer before replacing the nozzle assembly. Remove the existing left hotend following the Creator 4 service instructions, install the Flashforge Left Nozzle Assembly-HT (0.4 mm) in the left hotend position, and secure all connections. After installation, heat the hotend to the recommended operating temperature for the filament in use and perform a test print to confirm correct extrusion and alignment.

Recommendations

Use this HT 0.4 mm left nozzle assembly when working with filaments that require higher extrusion temperatures or when seeking consistent 0.4 mm extrusion. Regularly check for wear and clean according to Flashforge maintenance guidelines to preserve print quality.